The efficient design of new earth structures and the restoration of old structures both require a reliable assessment of the compressive strength of earth materials. However, there is still much debate on the best method to accurately measure the compressive strength of earth blocks. To solve the problem of measuring the compressive strength of the earth block, the cube specimen, the half‐block stacked specimen, and the full‐size block specimen are used to measure the compressive strength of the molded adobe and rammed adobe, respectively, considering the influence of the specimen preparation process, loading direction, capping, and other factors. By comparing and analyzing the stress state, failure mode, and compressive strength of the specimen under various test methods, a compressive strength test method of earth blocks is determined, which is simple to operate, easy to standardize, and as close as possible to the actual strength of the blocks. The results show that the full‐size block compression test method along the block thickness direction should be preferred to test the compressive strength of the earth block. The standard specimen obtained by cutting the full‐size block is not suitable for the test of the compressive strength of the earth block; it can effectively solve the problem that the compressive strength of the small‐thickness earth block cannot be directly measured by cutting the full‐size block in half and stacking it, but it is not recommended to use the binder to bond the two half‐blocks. When comparing the compressive strength of the earth blocks, the conversion coefficient related to the height‐to‐thickness ratio of the specimen cannot be used to convert the compressive strength. Still, the anisotropy of the material strength should be considered.
1 November 2021 in Journal of Building Engineering
This work explored the fluid–structure interaction (FSI) effect of crude oil and pipeline and the vibration characteristics of the pipe–crude oil structural system. A finite element computational analysis theory and corresponding simulation method were proposed for crude oil pipelines considering the FSI effect. Meanwhile, the spring model of the FSI interface between crude oil and pipeline was proposed. The experimental simulation and neural network were adopted to obtain the flow-excited pulsation pressure (FEPP), and the kinetic equations of the pipe–crude oil FSI were analyzed. The finite element computation (FEC) model for pipe–crude oil bi-directional FSI dynamics was established, which was composed of five support span lengths and four pipe liquid levels and can provide five different crude oil fluid velocities. One hundred orthogonal simulation test conditions were designed. In addition, the displacement response and acceleration response under FSI of the pipe wall were calculated, and the first six orders of inherent frequencies and main vibration patterns of the FEC model were analyzed. The results revealed that the dynamic effect of FSI between the crude oil transport medium and pipeline was complex and was influenced by the length of the pipeline crossing section, medium flow velocity, difference of liquid surface height, and displacement response. The acceleration response possessed prominent vibration decay characteristics, and the response peak in the same condition was about 8.2 times larger than that of the steady-flow state response. Therefore, the effect changed the inherent frequency and vibration pattern of the pipeline, to which the engineering design should pay sufficient attention.
Affected by climate warming and anthropogenic disturbances, the thermo-mechanical stability of warm and ice-rich frozen ground along the Qinghai–Tibet Railway (QTR) is continuously decreasing, and melting subsidence damage to existing warm frozen soil (WFS) embankments is constantly occurring, thus seriously affecting the stability and safety of the existing WFS embankments. In this study, in order to solve the problems associated with the melting settlement of existing WFS embankments, a novel reinforcement technology for ground improvement, called an inclined soil–cement continuous mixing wall (ISCW), is proposed to reinforce embankments in warm and ice-rich permafrost regions. A numerical simulation of a finite element model was conducted to study the freeze–thaw process and evaluate the stabilization effects of the ISCW on an existing WFS embankment of the QTR. The numerical investigations revealed that the ISCW can efficiently reduce the melt settlement in the existing WFS embankment, as well as increase the bearing capacity of the existing WFS embankment, making it favorable for improving the bearing ability of composite foundations. The present investigation breaks through the traditional ideas of “active cooling” and “passive protection” and provides valuable guidelines for the choice of engineering supporting techniques to stabilize existing WFS embankments along the QTR.