This paper proposes a current reference control method for shunt active power filter under unbalanced and distorted supply voltage conditions. The method uses the Kalman filter and the symmetrical component method to obtain the fundamental sequence component of the supply voltage. The Fryze-Buchholz-Dpenbrock method is used to decompose the load current under the reference of the fundamental positive-sequence voltage to obtain the reference value of the compensation current. The method is characterized without need of coordinate transformation, simple calculation, and clear physical meaning. The harmonic current, reactive current and negative sequence current can be compensated at the same time even under the condition of unbalanced supply voltage. The proposed method is compared with the traditional method under various experimental conditions to prove the validity and accuracy of the proposed method. The results show that the proposed method has wider applicability.
Maximum power point tracking (MPPT) control is a key technology for increasing the power generation of photovoltaic arrays under varying light and temperature conditions. Traditional perturb and observe methods and incremental conductance methods can achieve good tracking performance for single-peak characteristics. However, under complex conditions such as partial shading or dust accumulation, the power-voltage curve of a photovoltaic array exhibits multi-peak characteristics. In such cases, traditional methods may get trapped in local optima, preventing the photovoltaic array from operating at the maximum power point. Swarm intelligence algorithms perform well when solving multi-extremum functions and can be used for MPPT control of photovoltaic arrays in complex environments. Therefore, this paper focuses on the fireworks algorithm (FWA). To improve the computational speed and global optimization capability of the FWA, the characteristics of each stage of the algorithm are analyzed, a comprehensive improved fireworks algorithm (CIFWA) is proposed, and it is applied to the MPPT control of photovoltaic systems. The improved algorithm introduces an adaptive resource allocation and selection strategy with community inheritance features and applies tent chaos mapping to the algorithm’s explosion behavior. Multiple sets of test functions are used to compare the performance metrics of the optimization algorithm, demonstrating improvements in computational speed and global search capability of CIFWA. Finally, a control strategy for the MPPT of photovoltaic arrays based on CIFWA is presented, and a simulation experimental platform is built to analyze and verify the control performance.