Rodrigo Munguía

Dr. Rodrigo Munguía

Department of Computer Science, CUCEI, University of Guadalajara, Blvd. Marcelino Garca Barragn 1421, C.P. 44430 Guadalajara, Jalisco, México
orcid

Research Focus & Metrics

Academic Career Length

21Years (2006-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
15 March 2016 in Sensors
Verified
Journal Article
Open access
PDF file
Rodrigo MunguíaRodrigo Munguía
Rodrigo Munguía
SUSarquis Urzua
Sarquis Urzua
Yolanda BoleaYolanda Bolea
Yolanda Bolea
Antoni GrauAntoni Grau
Antoni Grau
The present paper describes a vision-based simultaneous localization and mapping system to be applied to Unmanned Aerial Vehicles (UAVs). The main contribution of this work is to propose a novel estimator relying on an Extended Kalman Filter. The estimator is designed in order to fuse the measurements obtained from: (i) an orientation sensor (AHRS); (ii) a position sensor (GPS); and (iii) a monocular camera. The estimated state consists of the full state of the vehicle: position and orientation and their first derivatives, as well as the location of the landmarks observed by the camera. The position sensor will be used only during the initialization period in order to recover the metric scale of the world. Afterwards, the estimated map of landmarks will be used to perform a fully vision-based navigation when the position sensor is not available. Experimental results obtained with simulations and real data show the benefits of the inclusion of camera measurements into the system. In this sense the estimation of the trajectory of the vehicle is considerably improved, compared with the estimates obtained using only the measurements from the position sensor, which are commonly low-rated and highly noisy.

26 April 2018 in Sensors
Verified
Journal Article
Open access
PDF file
Juan Carlos Trujillo FloresJuan Carlos Trujillo Flores
Juan Carlos Trujillo Flores
Rodrigo MunguíaRodrigo Munguía
Rodrigo Munguía
EGEdmundo Guerra
Edmundo Guerra
Antoni GrauAntoni Grau
Antoni Grau
This work presents a cooperative monocular-based SLAM approach for multi-UAV systems that can operate in GPS-denied environments. The main contribution of the work is to show that, using visual information obtained from monocular cameras mounted onboard aerial vehicles flying in formation, the observability properties of the whole system are improved. This fact is especially notorious when compared with other related visual SLAM configurations. In order to improve the observability properties, some measurements of the relative distance between the UAVs are included in the system. These relative distances are also obtained from visual information. The proposed approach is theoretically validated by means of a nonlinear observability analysis. Furthermore, an extensive set of computer simulations is presented in order to validate the proposed approach. The numerical simulation results show that the proposed system is able to provide a good position and orientation estimation of the aerial vehicles flying in formation.

1 April 2014 in International Journal of Advanced Robotic Systems
Verified
Journal Article
Open access
Rodrigo MunguíaRodrigo Munguía
Rodrigo Munguía
Antoni GrauAntoni Grau
Antoni Grau
This paper describes a practical and reliable algorithm for implementing an Attitude and Heading Reference System (AHRS). This kind of system is essential for real time vehicle navigation, guidance and control applications. When low cost sensors are used, efficient and robust algorithms are required for performance to be acceptable. The proposed method is based on an Extended Kalman Filter (EKF) in a direct configuration. In this case, the filter is explicitly derived from both the kinematic and error models. The selection of this kind of EKF configuration can help in ensuring a tight integration of the method for its use in filter-based localization and mapping systems in autonomous vehicles. Experiments with real data show that the proposed method is able to maintain an accurate and drift-free attitude and heading estimation. An additional result is to show that there is no ostensible reason for preferring that the filter have an indirect configuration over a direct configuration for implementing an AHRS system.

7 July 2009 in IEEE Transactions on Instrumentation and Measurement
Verified
Journal Article
Closed access
Rodrigo MunguíaRodrigo Munguía
Rodrigo Munguía
Antoni GrauAntoni Grau
Antoni Grau
Monocular simultaneous localization and mapping (SLAM) techniques implicitly estimate camera ego-motion while incrementally building a map of the environment. In monocular SLAM, when the number of features in the system state increases, maintaining a real-time operation becomes very difficult. However, it is easy to remove old features from the state to maintain a stable computational cost per frame. If features are removed from the map, then previously mapped areas cannot be recognized to minimize the robot's drift; alternatively, in the context of a real-time virtual sensor that emulates typical sensors as laser for range measurements and encoders for dead reckoning, this limitation should not be a problem. In this paper, a novel framework is proposed to build in real time a consistent map of the environment using the virtual-sensor estimations. At the same time, the proposed approach allows minimizing the drift of the camera-robot position. Experiments with real data are presented to show the performance of this frame of work.

26 September 2019 in Sensors
Verified
Journal Article
Open access
PDF file
Rodrigo MunguíaRodrigo Munguía
Rodrigo Munguía
SUSarquis Urzua
Sarquis Urzua
Antoni GrauAntoni Grau
Antoni Grau
This work presents a method for estimating the model parameters of multi-rotor unmanned aerial vehicles by means of an extended Kalman filter. Different from test-bed based identification methods, the proposed approach estimates all the model parameters of a multi-rotor aerial vehicle, using a single online estimation process that integrates measurements that can be obtained directly from onboard sensors commonly available in this kind of UAV. In order to develop the proposed method, the observability property of the system is investigated by means of a nonlinear observability analysis. First, the dynamic models of three classes of multi-rotor aerial vehicles are presented. Then, in order to carry out the observability analysis, the state vector is augmented by considering the parameters to be identified as state variables with zero dynamics. From the analysis, the sets of measurements from which the model parameters can be estimated are derived. Furthermore, the necessary conditions that must be satisfied in order to obtain the observability results are given. An extensive set of computer simulations is carried out in order to validate the proposed method. According to the simulation results, it is feasible to estimate all the model parameters of a multi-rotor aerial vehicle in a single estimation process by means of an extended Kalman filter that is updated with measurements obtained directly from the onboard sensors. Furthermore, in order to better validate the proposed method, the model parameters of a custom-built quadrotor were estimated from actual flight log data. The experimental results show that the proposed method is suitable to be practically applied.

1 August 2014 in Journal of Applied Research and Technology
Verified
Journal Article
Open access
Rodrigo MunguíaRodrigo Munguía
Rodrigo Munguía
This work presents a practical method for estimating the full kinematic state of a vehicle, along with sensor error parameters, through the integration of inertial and GPS measurements. This kind of system for determining attitude and position of vehicles and craft (either manned or unmanned) is essential for real time, guidance and navigation tasks, as well as for mobile robot applications.The architecture of the system is based in an Extended Kalman filtering approach in direct configuration. In this case, the filter is explicitly derived from the kinematic model, as well as from the models of sensors error. The architecture has been designed in a manner that it permits to be easily modified, in order to be applied to vehicles with diverse dynamical behaviors.The estimated variables and parameters are: i) Attitude and bias-compensated rotational speed of the vehicle, ii) Position, velocity and bias-compensated acceleration of the vehicle and iii) bias of gyroscopes and accelerometers. Experimental results with real data show that the proposed method is enough robust for its use along with low-cost sensors