During drilling operations, mud continuous-wave signals suffer severe distortion at the surface receiver due to dynamic and complex background noise. Traditional noise cancelation methods face limitations in effectiveness and generalization. To address this, this paper proposes a particle swarm optimization (PSO)-based selective ensemble filtering strategy. It adaptively selects optimal filtering algorithms matched to the target scenario and assigns their weights, enabling complementary strengths from diverse filters. Preferred filtering methods are applied in parallel, generating initial signals as candidate solutions within the reconstructed ensemble. The PSO algorithm identifies the optimal matching weights for each particle and performs the optimal selective ensemble of these candidates. This process enhances generalization capability and achieves high-precision reconstruction of the continuous-wave signal in complex drilling environments. Experimental results demonstrate that the reconstructed signal using this method exhibits superior quality metrics and greater robustness compared to any single-filter output, validating the proposed approach’s effectiveness.
16 September 2022 in Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science
Due to erosion and corrosion, natural gas pipelines can be easily damaged, causing uneven corrosion defects on the inner surface of the elbow. The existence of uneven corrosion defects will affect the surface structure of the inner arch of the elbow. In this paper, the influence of uneven corrosion defects on the further corrosion of elbow was studied by computational fluid dynamics (CFD). The results show that the particles are distributed in a regular V-shape after hitting the outer arch of the non-defect elbow. However, part of the particles bounced irregularly after hitting the defect elbow, forming an irregular particle trajectory region. The uneven corrosion defects that have been created can affect the particle trajectory distribution. When the axial angle α is 45°–55° and the hoop angle φ is between 60° and 120°, the erosion of defect elbow is easily affected by corrosion pits. In addition, the maximum erosion rate of non-defect elbow can be increased with the increase of particle diameter. However, in terms of the impact of particle diameter on erosion, there are two inflection points in the maximum erosion rate of the defect elbow, showing the trend of “increase,”“decrease” and “increase.” The research can provide a theoretical support for subsequent engineering applications.