Nick G Glumac

Nick G Glumac

orcid

Research Focus & Metrics

Academic Career Length

17Years (2010-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
30 June 2010 in Combustion Science and Technology
Verified
Journal Article
Closed access
PLPatrick Lynch
Patrick Lynch
GFGiovanni Fiore
Giovanni Fiore
HKHerman Krier
Herman Krier
Nick G GlumacNick G Glumac
Nick G Glumac
The presence or absence of gas phase species during combustion of aluminum nanoparticles (n-Al) is a crucial observable in evaluating competing theories such as a diffusive oxidation mechanism and the melt dispersion mechanism. Absorption spectroscopy was used to probe the ground state of aluminum monoxide (AlO) and Al vapor in order to quantify the amount of Al and AlO present under conditions where these species were not observed in emission previously. Absorption measurements were made during combustion of nanoaluminum and micron-sized aluminum in a heterogeneous shock tube. AlO was detected in absorption at temperatures as low as 2000 K in n-Al combustion, slightly below the limit seen in micro-Al combustion. Al vapor was detected during n-Al combustion at temperatures as low as 1500 K, significantly lower than in micro-Al combustion, suggestive of a gas phase component. The detection limit for Al vapor was 1 × 1012 cm−3. The gas phase component was much weaker than that seen in 10 μm Al combustion. A comparison with n-Al in an inert environment did not show Al vapor at temperatures below 2300 K, even though the equilibrium concentration of Al from particles at that temperature were several orders of magnitude higher than the detection limit. This suggests a nearly pristine oxide coat that inhibits the production of Al vapor in appreciable quantities without reaction. These results are contrary to predictions of the melt dispersion mechanism, which should result in the generation of aluminum vapor from high-energy Al clusters produced from n-Al particles that spallate from mechanical stresses under rapid heating. This should further be independent of the bath gas.

11 February 2013 in Propellants, Explosives, Pyrotechnics
Verified
Journal Article
Closed access
PDF file
JPJennifer Mott Peuker
Jennifer Mott Peuker
PLPatrick Lynch
Patrick Lynch
HKHerman Krier
Herman Krier
Nick G GlumacNick G Glumac
Nick G Glumac

1 April 2010 in Propellants, Explosives, Pyrotechnics
Verified
Journal Article
Closed access
PDF file
TBTim Bazyn
Tim Bazyn
PLPatrick Lynch
Patrick Lynch
HKHerman Krier
Herman Krier
Nick G GlumacNick G Glumac
Nick G Glumac

20 November 2013 in Journal of Energetic Materials
Verified
Journal Article
Closed access
ACAndrew Coverdill
Andrew Coverdill
CDChristopher Delaney
Christopher Delaney
AJAndrew Jennrich
Andrew Jennrich
HKHerman Krier
Herman Krier
Nick G GlumacNick G Glumac
Nick G Glumac
Tungsten is mechanically alloyed with zirconium and subject to explosive initiation in confined chamber tests. Transient pressure measurements and residue analysis suggest that a majority of the tungsten reacts within 10 ms in alloys containing 33, 57, and 75 w/w W (balance Zr). The product of tungsten oxidation is likely amorphous WO3, because no crystalline tungsten oxides are observed in X-ray analysis of the residues. These results suggest that the chemical energy of tungsten can be extracted efficiently from mechanical alloys containing as little as 25% Zr, resulting in very high-density structural energetics that release chemical energy comparable to TNT on a mass basis.


11 March 2014 in Propellants, Explosives, Pyrotechnics
Verified
Journal Article
Closed access
PDF file
MCMichael D. Clemenson
Michael D. Clemenson
SJStephanie Johnson
Stephanie Johnson
HKHerman Krier
Herman Krier
Nick G GlumacNick G Glumac
Nick G Glumac