Jeong YG, et al. J Adv Prosthodont. 2018 Jun;10(3):245-251. https://doi.org/10.4047/jap.2018.10.3.245

Lee WS, et al. J Adv Prosthodont. 2017 Aug;9(4):265-270. https://doi.org/10.4047/jap.2017.9.4.265

Numerous studies have previously evaluated the marginal and internal fit of fixed prostheses; however, few reports have performed an objective comparison of the various methods used for their assessment. The purpose of this study was to compare five marginal and internal fit assessment methods for fixed prostheses. A specially designed sample was used to measure the marginal and internal fit of the prosthesis according to the cross-sectional method (CSM), silicone replica technique (SRT), triple scan method (TSM), micro-computed tomography (MCT), and optical coherence tomography (OCT). The five methods showed significant differences in the four regions that were assessed (p < 0.001). The marginal, axial, angle, and occlusal regions showed low mean values: CSM (23.2 µm), TSM (56.3 µm), MCT (84.3 µm), and MCT (102.6 µm), respectively. The marginal fit for each method was in the range of 23.2–83.4 µm and internal fit (axial, angle, and occlusal) ranged from 44.8–95.9 µm, 84.3–128.6 µm, and 102.6–140.5 µm, respectively. The marginal and internal fit showed significant differences depending on the method. Even if the assessment values of the marginal and internal fit are found to be in the allowable clinical range, the differences in the values according to the method should be considered.

This study aimed to evaluate the intaglio surface trueness of interim dental crowns fabricated with three 3-dimensional (3D) printing and milling technologies. Dental crown was designated and assigned as a computer-aided design (CAD) reference model (CRM). Interim dental crowns were fabricated based on CRM using two types of 3D printer technologies (stereolithography apparatus and digital light processing) and one type of milling machine (n = 15 per technology). The fabricated interim dental crowns were obtained via 3D modeling of the intaglio surface using a laboratory scanner and designated as CAD test models (CTMs). The alignment and 3D comparison of CRM and CTM were performed based on the intaglio surface using a 3D inspection software program (Geomagic Control X). Statistical analysis was validated using one-way analysis of variance and Tukey HSD test (α = 0.05). There were significant differences in intaglio surface trueness between the three different fabrication technologies, and high trueness values were observed in the milling group (p < 0.05). In the milling group, there was a significant difference in trueness according to the location of the intaglio surface (p < 0.001). In the manufacturing process of interim dental crowns, 3D printing technologies showed superior and uniform manufacturing accuracy than milling technology.