Unbalanced fault is the most common fault of high‐speed motorized spindle, which is the main factor affecting the machining accuracy of high‐speed spindle. Due to the unbalanced magnetic pull produced by the air gap eccentricity of the stator and rotor, the unbalanced vibration of the motorized spindle will be further aggravated. In order to explore the dynamic behavior and motion law of the unbalanced fault motorized spindle under the eccentric state, a dynamic model of the unbalanced fault of the high‐speed motorized spindle considering the unbalanced magnetic pull was established. Taking the eccentric motorized spindle customized by the research group as the research object, the dynamic model is established, simulated, and analyzed, and the response change law of motorized spindle under the effect of different speed, unbalance, and air gap is obtained. The simulation results show that the unbalanced magnetic pull caused by static eccentricity will increase the unbalanced vibration of motorized spindle, and the unbalanced vibration will also increase with the increase of static eccentricity. The vibration caused by unbalanced magnetic pull does not increase with the increase of rotating speed. In frequency‐domain analysis, when there is unbalanced magnetic pull, the peak appears at 0 Hz, and the amplitude of fundamental frequency vibration will increase with the increase of eccentricity. The experimental results show that the greater the eccentricity is, the greater the unbalance vibration of the motorized spindle is. The experimental results are consistent with the simulation results, which further verify the accuracy of the model. The research results lay a theoretical basis for fault analysis and diagnosis of coupling fault motorized spindle.
At normal operating temperatures (below 100 °C), the water in the proton exchange membrane fuel cell (PEMFC) is in the form of a mixture of gas and liquid phases. The content of water guarantees that the membrane has good proton conductivity, but it may also block the transmission of the reaction gas to the catalytic reaction sites. Based on the single straight channel of the PEMFC, the water content of the model at various voltages and the water distribution of the different parts are studied. The results indicate that the amount of water in the model generally increases with the reduction in the voltage. When the voltage is set from 1.1 V to 0.7 V, the increase in the amplitude of the water content is higher than 0.7 V–0.4 V, and the water content is highest at 0.5 V. Under each voltage, the largest water content occurs in the gas diffusion layer, the second one occurs in the channel, the third one occurs in the proton exchange membrane, and the water content in the catalyst layer is lowest.
1 March 2021 in Journal of Physics: Conference Series
In order to reduce the influence of heat produced by motorized spindle on the machining performance, cooling of motorized spindle need to be studied. Based on the multiple linear regression theory, the motorized spindle cooling model was established according to the temperature conditions of different cooling water temperatures and flow rates for the cooling process of the motorized spindle temperature. The validity of the model was verified by three verification methods. Based on the experimental data, the numerical simulation model of the motorized spindle cooling is established. It is effective and reliable to verify the mathematical model of the motorized spindle cooling with three test methods. The results showed the cooling prediction model of motorized spindle was relatively stable.