The density, porosity, and strength of rocks are fundamental in the design of geo-engineering projects. Determining these properties requires the preparation of smooth core samples, which is usually impossible for soft rocks. Besides, only fragmented samples may be available in some projects. A method for predicting rock properties from rock particles such as drilling debris would therefore be useful. This study was undertaken to develop prediction equations for compressive strength (UCS), tensile strength (BTS), density, and porosity values from the crushability index (CI) obtained from rock fragments. The results showed that UCS, BTS, density, and porosity were strongly correlated with the CI. The physical characteristics and strength of rocks may be predicted with the help of the derived equations. The CI test is a valuable tool for estimating rock properties in drilling projects and in situations where core specimens are not available.
Full-face tunnel boring machines (TBMs) can be used to excavate hard rocks, but there are still significant issues with low advance rate and high cutter wear. However, roadheaders and other mechanical excavators are unable to cut hard rocks. Research on microwave-assisted excavation has gained attention recently in an effort to decrease cutter wear, increase the TBM advance rate in hard rock excavation, and enable the mechanical excavation of hard rocks using machines other than TBMs. Nevertheless, neither a laboratory nor a field-based integrated microwave-assisted excavation machine is currently in use. The present paper aims to examine the cuttability of carbonate rock samples in the laboratory using an integrated microwave-assisted linear cutting machine which has just been developed. Samples of carbonate rock were gathered from Türkiye and Romania, and both untreated and treated samples underwent cutting tests with a pointed pick. For both non-microwave and microwave-assisted cutting experiments, optimum specific energy values for each sample were determined. During microwaving at 15 kW, when comparing optimum specific energy values to those of non-microwave cutting, notable decreases were seen. The evaluation of the findings demonstrated the economic viability of cutting carbonate rocks with microwave assistance.
Roadheaders are extensively utilized for tunnel heading rock engineering applications all over the world. To create a work plan and calculate costs, it is critical to forecast roadheader performance as precisely as possible. Machine utilization time (MUT) is required for the calculation of daily advance rate of roadheaders. This paper investigates the values of MUT for roadheaders used in underground coal mines. The performance measurements were conducted on fifty different locations for axial machines and thirty-nine different locations for transverse machines. MUT values vary from 15 % to 37.5 % with an average of 26.3 % for axial roadheaders, and vary from 6.9 % to 37.9 % with an average of 18.4 % for transvers roadheaders. The average MUT is 25.4% for all measurements. The percentage of average support time approximately equals to the average MUT. Multiple regression and artificial neural network models were also developed for estimating MUT. Concluding remark is that the determined MUT values and the derived estimation models for roadheaders will be very useful for coal miners.