Gas foil bearings (GFBs) have many noticeable advantages over the conventional rigid gas bearings, such as frictional damping of the compliance structure and tolerance to the rotor misalignment, so they have been successfully adopted as the key element that makes possible oil-free turbomachinery. As the adoption of the GFB increases, one of the critical elements for its successful implementation is thermal management. Even though heat generation inside the GFB is small due to the low viscosity of the lubricant, many researchers have reported that the system might fail without an appropriate cooling mechanism. The objective of the current research is to demonstrate the reliability of GFBs installed in the hot section of a micro-gas turbine (MGT). For the cooling of the GFBs, we designed a secondary flow passage and thermohydrodynamic (THD) analysis has been done for temperature prediction. In the analysis, the 3D THD model for the radial GFB extended to include the surrounding structure, such as the plenum, chamber, and the rotor in the solution domain by solving global mass and energy balance equations. In the MGT, the pressurized air discharged from the compressor wheel was used as the cooling air source, and it was injected into the plenum between two radial GFBs. We monitored the pressure and temperature of the cooling air along the secondary flow passage during the MGT operation. No thermal instability occurred up to the maximum operation speed of 43,000 rpm. The test results also showed that the pressure drop between the main reservoir and the plenum increases with an increasing operation speed, which indicated an increased cooling air flow into the plenum. The plenum and bearing sleeve temperature was maintained close to the cooling air source temperature for the entire speed due to a sufficient cooling air flow into the bearing. In addition, the direct injection of the cooling air from the main stream lowered the bearing sleeve temperature by 5–20 °C over the injection through the reservoirs. The predicted plenum and bearing sleeve temperatures with the developed THD model show good agreement with the test data.

A design process for cryogenic expanders that supplies 0.5 TPD of liquefied hydrogen in hydrogen liquefaction plants is introduced. To improve the efficiency of the expander, the optimum design was conducted by adjusting two rotor shape parameters. The designed expander for hydrogen liquefaction has a target rotation speed of 75,000 rpm, and helium is applied as the working fluid. Since the operating temperature of the expander is as low as 49 K, a design that reflects the real gas properties must be considered. For a high-efficiency hydrogen liquefaction plant, increasing the expander efficiency is one of the most critical issues. In this study, the efficiency of the cryogenic expander was optimized using the response surface method (RSM). The hub and shroud meridional contours and blade $\beta$ angle distributions were chosen as the design parameters. As a result, through the optimized design, it was possible to improve the expander efficiency by up to 1.98% compared to the original expander. Flow analysis was conducted to investigate the reason for the efficiency improvement. Through this study, the effect of the blade meridional contour and blade $\beta$ angle on the cryogenic expander efficiency was verified.

This study designed an externally pressurized bearing and analyzed the rotordynamics of a turbo expander for a hydrogen liquefaction plant. The turbo expander, comprising a turbine and compressor wheel assembled to a shaft, lowered the temperature of the helium refrigerant. Its rated speed was 75,000 rpm, and an externally pressurized gas bearing was selected to support the rotor. Pressurized helium was used as the lubricant for the bearing operation. To design the rotor–bearing system, we conducted a bearing performance analysis and rotordynamic characteristic prediction using the developed numerical model. We calculated the bearing stiffness and flow rate of the bearing gas for various feed parameters and selected the appropriate orifice diameter for maximum stiffness. The predicted Campbell diagram showed that the system had a sufficient separation margin with the critical speed, and the predicted critical speed correlated well with the nonlinear orbit simulation. A successful operation was achieved with the manufactured turbo expander within the rated speed. The shaft vibration was monitored during the operation test, and the test results revealed two critical speeds below the rated speed, as predicted by the analytical model. In addition, the shaft vibration was maintained at <3 μm.