This paper presents comparation of the deviation between part made by Fused Deposition Modeling (FDM) and injected molded part. The paper also presents a system for determine deviation of plastic parts. The presented system is used for part design and both types of manufacturing.
Plastic injection molding (IM) is a complex and technologically demanding process; therefore, it is characterised by IM parameters and material properties that influence the product quality. Setting satisfactory IM parameters requires knowledge of the processing properties of the material, the mold shape, and the technological capacity of the injection molding machine (IMM). Injection shrinkage causes changes in the shape and dimensions of the molded parts; therefore, it is one of the most significant problems that must be solved, both during the mold design phase and the numerical simulation phase. The paper presents determined IM parameters as well as material parameters influencing the value of the shrinkage. The conducted experimental tests were related to selected topics connected with the injection process and considered the change of the processed material characteristics, and change of certain, relatively the simplest to regulate IM parameters. Geometrical Product Specification (GPS) of the molded part was measured using two methods: Contact and Non-contact (3D scanning). The analysis of injection shrinkage illustrates that an effective influence on its value is possible by selecting appropriate IM parameters and material condition. The connection between the shrinkage and different filler concentration was established.