Thorium-229 possesses the lowest first nuclear excited state, with an energy of approximately 8 eV. The extremely narrow linewidth of the first nuclear excited state, with an uncertainty of 53 THz, prevents direct laser excitation and realization of the nuclear clock. We present a proposal using the Coulomb crystal of a linear chain formed by $$^{229}$$ Th $$^{3+}$$ ions, where the nuclei of $$^{229}$$ Th $$^{3+}$$ ions in the ion trap are excited by the electronic bridge (EB) process. The 7 $$P_{1/2}$$ state of the thorium-229 nuclear ground state is chosen for EB excitation. Using the two-level optical Bloch equation under experimental conditions, we calculate that 2 out of 36 prepared thorium ions in the Coulomb crystal can be excited to the first nuclear excited state, and it takes approximately 2 h to scan over an uncertainty of 0.22 eV. Taking advantage of the transition enhancement of EB and the long stability of the Coulomb crystal, the energy uncertainty of the first excited state can be limited to the order of 1 GHz.
9 May 2024 in Journal of Physics D: Applied Physics
We present a detailed method for accumulating Ca+ ions controllably in a linear Paul trap. The ions are generated by pulsed laser ablation and dynamically loaded into the ion trap by switching the trapping potential on and off. The loaded ions are precooled by buffer gas and then laser-cooled to form Coulomb crystals for verifying quantity. The number of ions is controlled by manipulating the trapping potential of the ion trap, partial pressure of buffer gas and turn-on time of the entrance end cap voltage. With single-pulse laser ablation, the number of trapped ions ranges from tens to ten thousand. The kinetic energy of loaded ions can be selected via the optimal turn-on time of the entrance end cap. Using multiple-pulse laser ablation, the number is further increased and reaches about . The dynamic loading method has wide application for accumulating low-yielding ions via laser ablation in the ion trap.
Various charged thorium ions such as singly charged, doubly charged, and triply charged thorium ions trapped in the ion trap can be used to excite the Th-229 first nuclear excited state via the electronic bridge process. We present an integration of a linear ion trap with a time-of-flight mass spectrometer to investigate trapped Th-232 ions. Various charged thorium ions are produced by laser ablation and dynamically loaded into the ion trap. After sufficient collisional cooling, thorium ions are extracted along one of the radial directions for time-of-flight mass spectrometry by rapidly quenching the trapping potential and applying high-voltage extracting pulses. The charge states of thorium ions are identified and the maximum mass resolutions of thorium ions reach ∼100 with initial 300 K collisional cooling. The velocity distributions of ablated various charged thorium ions are measured, and the results agree well with Monte Carlo simulation. Lifetimes of thorium ions are determined to be a few tens of seconds in the ion trap, which are helpful for further spectroscopic studies of Th-229 nuclear transition.
We demonstrate a modified integration of a linear ion trap with a time-of-flight mass spectrometer optimized to enhance the loading and detection of Th3+ ions. A phase-locked radiofrequency/high-voltage switch incorporating zero-crossing triggering and a programmable time delay is a key upgrade to minimize RF phase-dependent jitter and enable the unambiguous identification of Th3+ ions. To enhance purity, yield, and lifetime of trapped Th3+ ions, we optimize the ion loading parameters, including ion trap settings (RF amplitude, endcap voltages, and loading time), laser-ablation pulse energy, helium partial pressure, and ion storage time. These improvements extend trapping lifetimes of Th3+ ions to several hundred seconds, representing an order-of-magnitude increase compared to our previous work. Finally, single-pulse ablation of mixed Sr–Th nitrate targets enables the direct co-loading of Th3+ and 88Sr+ ions, and subsequent laser cooling forms multi-component Coulomb crystals for laser spectroscopy of Th3+ ions. Given the long trapping lifetime of Th3+ ions, this system will serve as a platform for developing a prototype trap-based thorium nuclear clock.
Through finite-element simulation, the axial potential distribution of the ion trap is analyzed. The effects of the central hole diameter of the end cap and the spacing between the two end caps on the axial geometric parameters of the ion trap are investigated. Based on these findings, a set of linear Paul traps is designed by selecting suitable end caps and quadrupoles. Stable trapping of calcium ions (Ca+) is successfully achieved, and these ions are subsequently laser-cooled into ionic Coulomb crystals. In the experiment, secular motion excitation of the Ca+ ion Coulomb crystal is performed, yielding an axial geometric parameter of 0.115(1) for the ion trap. This value aligns well with the simulation result of 0.114(2). The precise determination of the axial geometric parameter provides a solid foundation for subsequent high-precision optical or mass spectrometry measurements.