Small vessels (<10 m) radiate underwater noise in sensitive coastal environments, but there is insufficient knowledge of their noise radiation. Through detailed measurements of seven small boats and a jet ski in a shallow water environment on the Swedish west coast, this study presents results on the speed dependence of small vessel underwater noise, its sources, and its directivity. For vessels with planing hulls, broadband source levels increase with speed until planing is attained. When planing, source level dependence on speed is weak. A detailed noise source analysis of one vessel showed that at low speed, tonals from the engine dominate the noise radiation, whereas at higher speeds, propeller tonals and broadband noise dominate. Noise radiation into different horizontal angles shows little angle dependence, and noise levels relative to the closest point of approach show a similar pattern across all investigated vessels. Received noise levels at approximately 100 m range are not high enough to cause hearing impairment in marine animals, but fast-moving small vessels may cause behavioural reactions or stress responses across several marine animal groups.
Underwater radiated noise from small recreational vessels can have significant ecological impacts on near-shore habitats, yet it is often overlooked in soundscape assessments. The objective of this study is to present measured source levels for small recreational vessels and to evaluate an existing source level model (JOMOPANS-ECHO model). The existing model was developed based on data from larger vessels, and the current study focuses on how to modify it for smaller vessels with different hull types. Errors associated with shallow water measurements are also discussed; more specifically, existing methods for accounting for propagation loss are evaluated. Controlled measurements were conducted at five coastal sites for 25 vessels spanning different hull forms, propulsion systems, and operational speeds. Frequency-dependent source level spectra were derived and categorised by hull class (planing, semi-displacement, displacement). The results show clear speed-dependent increases in source level for planing and semi-displacement vessels at higher frequencies (>250 Hz), whereas data for displacement vessels were insufficient to establish statistical trends. The JOMOPANS-ECHO model consistently overestimates the speed dependence. The parameterisations developed here provide class- and speed-specific models suitable for integration into soundscape mapping and cumulative impact assessments.
In September 2024, the HELCOM Expert Group on Underwater Noise (EG Noise) convened an intercalibration workshop at the Swedish Defence Research Agency (FOI) to demonstrate and practice calibration procedures for autonomous hydrophone systems used in Baltic Sea continuous noise monitoring. While many national programs still rely on single-frequency pistonphone checks that implicitly assume a flat frequency response, the workshop explored broadband, projector-based free-field calibration as a complementary approach. Calibrations were performed using a projector with known transmitter voltage response in FOI’s indoor basin (2–10 kHz) and at an open-sea pontoon in the Stockholm archipelago (800 Hz–20 kHz). The resulting frequency-response curves for multiple recorder systems showed deviations from flat sensitivity and between-system variability, underscoring the need for regular broadband checks to interpret long-term monitoring data. Beyond calibrations, participants reviewed rig designs, deployment geometries, and noise-mitigation practices, and distilled practical rules for recorder deployments. This chapter synthesizes these practices and presents representative curves from the workshop. It clarifies the limitations of pistonphone calibrations and thereby highlights the needs for regular broadband free-field calibrations.
In September 2024, the HELCOM Expert Group on Underwater Noise (EG Noise) convened an intercalibration workshop at the Swedish Defence Research Agency (FOI) to demonstrate and practice calibration procedures for autonomous hydrophone systems used in Baltic Sea continuous noise monitoring. While many national programs still rely on single-frequency pistonphone checks that implicitly assume a flat frequency response, the workshop explored broadband, projector-based free-field calibration as a complementary approach. Calibrations were performed using a projector with known transmitter voltage response in FOI’s indoor basin (2–10 kHz) and at an open-sea pontoon in the Stockholm archipelago (800 Hz–20 kHz). The resulting frequency-response curves for multiple recorder systems showed deviations from flat sensitivity and between-system variability, underscoring the need for regular broadband checks to interpret long-term monitoring data. Beyond calibrations, participants reviewed rig designs, deployment geometries, and noise-mitigation practices, and distilled practical rules for recorder deployments. This chapter synthesizes these practices and presents representative curves from the workshop. It clarifies the limitations of pistonphone calibrations and thereby highlights the needs for regular broadband free-field calibrations.
1 September 2022 in The Journal of the Acoustical Society of America
A method is presented for simultaneous estimation of the probability distributions of both anthropogenic and wind-generated underwater noise power spectral density using only acoustic data recorded with a single hydrophone. Probability density models for both noise sources are suggested, and the model parameters are estimated using the method of maximum likelihood. A generic mixture model is utilized to model a time invariant anthropogenic noise distribution. Wind-generated noise is assumed normally distributed with a wind speed-dependent mean. The mean is then modeled as an affine linear function of the wind-generated noise level at a reference frequency, selected in a frequency range where the anthropogenic noise is less dominant. The method was used to successfully estimate the wind-generated noise spectra from ambient noise recordings collected at two locations in the southern Baltic Sea. At the North location, 3 km from the nearest shipping lane, the ship noise surpasses the wind-generated noise almost 100% of the time in the frequency band 63–400 Hz during summer for wind speed 7 m/s. At the South location, 14 km to the nearest shipping lane, the ship noise dominance is lower but still 40%–90% in the same frequencies and wind speed.