Two-dimensional organic-inorganic hybrid halide perovskites have garnered much attention owing to their outstanding stability alongside unique quantum-well structures and anisotropic properties, leading to improved charge dynamics. Two-dimensional perovskites can be divided into three phases including Ruddlesden-Popper, Dion-Jacobson, and Alternating cations in the interlayer space phase. Each phase of these perovskites shows distinguished phase-dependent structural and optoelectrical properties. Tuning their properties by designing the materials can be a key strategy to enhance the device performance in optoelectrical applications. Configuration of spacer cations and the control of octahedral layer numbers (n ) can be important parameters in material design, enabling the tuning of dielectric properties, exciton binding energy, and bandgaps, as well as materials structures, thereby influencing stability and charge transport behaviors. In this point, two-dimensional perovskite single crystals can play essential roles in not only understanding phase-dependent intrinsic natures but also enhancing performance of optoelectronic applications, specifically owing to their long carrier diffusion length and enhanced stability with little grain boundaries and low trap density. This review will deliver the strategy of phase-dependent materials design with an understanding of their anisotropic properties and charge dynamics for optoelectronic applications, including photodetectors and X-ray detectors.
2D halide perovskites such as BA 2 PbBr 4 exhibit highly anisotropic optoelectronic properties arising from their unique layered crystal structure. While most previous studies have focused on polycrystalline thin films, single‐crystal systems remain less explored, and the influence of crystallographic facet orientation on their electronic and ionic behavior is still not well understood. In this study, we systematically investigated the charge dynamics and electrostatic response of single‐crystal BA 2 PbBr 4 on both cross‐sectional and normal surfaces using Kelvin probe force microscopy (KPFM). Under different light illumination and bias voltage, the distinct variation in contact potential difference (CPD) reveals enhanced screening of positively charged bromine vacancies and stronger light‐induced tip‐induced band bending (TIBB) on cross‐section surfaces. Time‐dependent measurements show that ionic relaxation is slower; however, the relaxation of photoinduced charge is faster at cross‐section facets. These findings thus reveal intrinsic details of the anisotropic interplay of charge screening, ion migration, and trap states, which offer primary insight into single‐crystal 2D perovskite's facet‐dependent optical and electronic behavior. This understanding provides a foundation for rationally engineering facet orientation and defect chemistry to unlock the full potential of 2D perovskites in stable optoelectronic devices.
Green hydrogen production using membrane electrode assembly (MEA) has attracted significant attention due to its remarkable energy conversion efficiency. To further enhance its sustainability, MEA-based water electrolysis can be integrated with renewable solar energy by adopting a photocatalytic MEA (P-MEA) system, incorporating light-transmitting windows into MEA stacks, and employing suitable photocatalytic electrode materials. A critical challenge lies in developing cost-effective and high-performance photocatalytic electrode materials by replacing conventional noble material systems with earth-abundant photocatalytic electrode materials. This review discusses recent advances in P-MEA concepts and fabrication strategies for photoelectrodes tailored to MEA operation. Particular emphasis is placed on elucidating the mechanisms of light-induced charge dynamics that govern the P-MEA-based water electrolysis process. Overall, this review highlights the synergistic potential of integrating photocatalysis with MEA-based water electrolysis to advance sustainable green hydrogen production.