Maria de los Angeles Hernandez-Perez

Dr. Maria de los Angeles Hernandez-Perez

orcid

Research Focus & Metrics

Academic Career Length

13Years (2014-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 May 2020 in Vacuum
Verified
Journal Article
Closed access
MHMaria de los Angeles Hernandez-Perez
Maria de los Angeles Hernandez-Perez
ESElvia Angelica Sanchez-Ramirez
Elvia Angelica Sanchez-Ramirez
FCFredy Josealdo Castillo-Plata
Fredy Josealdo Castillo-Plata
AMArturo Manzo-Robledo
Arturo Manzo-Robledo
JAJorge Ricardo Aguilar-Hernandez
Jorge Ricardo Aguilar-Hernandez
ACAurora Amparo Flores Caballero
Aurora Amparo Flores Caballero

1 May 2014 in Electrochimica Acta
Verified
Journal Article
Closed access
RERamírez-Meneses Esther
Ramírez-Meneses Esther
ATA.M. Torres-Huerta
A.M. Torres-Huerta
MCMIGUEL A DOMINGUEZ C
MIGUEL A DOMINGUEZ C
MPM.G. Ponce-Varela
M.G. Ponce-Varela
MHMaria de los Angeles Hernandez-Perez
Maria de los Angeles Hernandez-Perez
EPEduardo Palacios-González
Eduardo Palacios-González

26 June 2017 in Materials Research
Verified
Journal Article
Open access
PDF file
ESElvia Angelica Sanchez-Ramirez
Elvia Angelica Sanchez-Ramirez
MHMaria de los Angeles Hernandez-Perez
Maria de los Angeles Hernandez-Perez
JAJorge Ricardo Aguilar-Hernandez
Jorge Ricardo Aguilar-Hernandez
EPElia Palacios-Beas
Elia Palacios-Beas
MVMaricela Villanueva-Ibañez
Maricela Villanueva-Ibañez
CdSe and CdS0.25Se0.75 thin films were grown by the Chemical Bath Deposition technique at different temperatures (50-90°C) and deposition times (5-180 min). Both kinds of films are polycrystalline, constituted by nanostructured clusters of particles. CdSe films consist in a mixture of cubic and hexagonal phases (4-8 nm crystal size), whereas only the hexagonal phase is observed in the CdS0.25Se0.75 ones (6±1 nm crystal size). A decrease on the CdSe films density was observed due to the sulfur introduction into the crystal lattice. The composition of the ternary films is affected by both temperature and deposition time. The Band gap values (Eg) are affected by temperature, atomic composition and deposition time, decreasing from 2.09 to 1.93 eV, showing a quantum confinement effect mainly in the CdSe films. The films thickness, ranging from 30 to 600 nm, increases as a function of temperature and deposition time. Photoluminiscence signal is improved after thermal treatment, evidenced by the radiative broad bands observed at 1.84 and 2.20 eV.

1 February 2021 in Materials Research Express
Verified
Journal Article
Open access
PDF file
MAM E Andrade-Sanchez
M E Andrade-Sanchez
MHMaria de los Angeles Hernandez-Perez
Maria de los Angeles Hernandez-Perez
GGGeorgina García-Pacheco
Georgina García-Pacheco
MOMayahuel Ortega-Avilés
Mayahuel Ortega-Avilés
This article reports the preparation of Co3O4 phase films by sol-gel. Initially, the precursor solution was prepared by the reaction of cobalt acetate tetrahydrate with methanol. Clean glass substrates were dipped into the solution for 4 times with a speed of dipping of 2 cm per minute. Afterwards, the films deposited were thermally treated at 500 °C to produce the Co3O4 phase. FTIR, UV-Vis and XRD techniques were used to analyze the effects of temperature and pH on reaction carried out on the precursor solution. While the microstructural characterization of thermally treated films was performed through XRD and SEM techniques. In parallel, were studied the thermal decompositions of both Co(CH3COO)2 phase as precursor solution S2 powders using TGA-DTA techniques. The results show that Co3(CH3COO)5OH phase was identified as the precursor to the Co3O4 phase. It was observed that the synthesis temperature promotes the formation reaction of Co(CH3COO)5OH. While the decrease in pH by addition of citric acid had 2 effects. The first was to delay the formation reaction, and the second was to decrease the particle size of phase Co3O4 < 10 nm.

2 March 2023 in Particle & Particle Systems Characterization
Verified
Journal Article
Closed access
SPSarahi Pacheco‐Espinoza
Sarahi Pacheco‐Espinoza
ACAlejandro I. Cuesta‐Balderas
Alejandro I. Cuesta‐Balderas
JVJorge Vázquez‐Lujano
Jorge Vázquez‐Lujano
ARAbril Rosiles‐Aguilera
Abril Rosiles‐Aguilera
MHMaria de los Angeles Hernandez-Perez
Maria de los Angeles Hernandez-Perez
LZLian‐Meng Zhang
Lian‐Meng Zhang

19 December 2025 in Nanomaterials
Verified
Journal Article
Open access
PDF file
ESElvia Angelica Sanchez-Ramirez
Elvia Angelica Sanchez-Ramirez
RARamón Arellano-Piña
Ramón Arellano-Piña
MHMaria de los Angeles Hernandez-Perez
Maria de los Angeles Hernandez-Perez
SBSimon Bello-Teodoro
Simon Bello-Teodoro
KGKarol Karla García-Aguirre
Karol Karla García-Aguirre
JAJorge Ricardo Aguilar-Hernandez
Jorge Ricardo Aguilar-Hernandez
Cadmium sulfide (CdS) nanoparticles are classified as II-VI semiconductor materials, used in optoelectronic devices due to a band gap (Eg). In this study, CdS nanoparticles were synthesized by the chemical precipitation method, and a systematic evaluation of pH (4.8–10.1) and temperature (50, 75, and 90 °C) was conducted. The effects of these variables were evaluated by UV-VIS spectroscopy, X-ray diffraction (XRD), and scanning electron microscopy (SEM). Results demonstrate that variables determine crystallite sizes (Cs), cluster sizes, and optical properties. CdS crystallization is more affected by pH conditions than by temperature during synthesis; the change in peak intensity in 2θ = 24–29° suggests the formation of a cubic phase (alkaline conditions) and a transition to a hexagonal phase (acidic conditions). Higher temperature improves the quality of the nanoparticles, as evidenced by the reduction in intensity of the peaks associated with secondary materials. The synthesis conditions of CdS nanoparticles significantly affect Eg, widening the range from 2.21 to 2.40 eV. Both temperature and pH conditions change the size of nanoparticles and clusters. Acid conditions promote the formation of rounded and uniform nanoparticles, while alkaline conditions form the largest crystals of CdS. These findings are useful for developing electronic devices that require different semiconductor profiles.