The increasing atmospheric concentration of CO2 is a major contributor to global climate change, underscoring the urgent need for effective strategies to convert CO2 into value-added products. In this sense, a composite was successfully synthesized by combining clinoptilolite zeolite (CZ) with varying amounts of copper oxide (CuO-1% and 10%) for CO2 photoreduction. The composites were characterized using insightful techniques, including XRD, nitrogen physisorption, DRS, and SEM. The results confirmed the incorporation and dispersion of CuO within the CZ support. The XRD analysis revealed characteristic crystalline CuO peaks. Despite the low surface area (<15 m2·g−1) and macroporous nature of the samples, EDS imaging revealed an effective and homogeneous dispersion of CuO, indicating efficient surface distribution. UV–Vis diffuse reflectance spectroscopy revealed band gap energies of 3.30 eV (CZ), 3.38 eV (1%-CuO/CZ), and 1.75 eV (10%-CuO/CZ), highlighting the pronounced electronic changes resulting from CuO incorporation. Photocatalytic tests conducted under UVC irradiation (λ = 254 nm) revealed that 10%-CuO/CZ exhibited the highest CO and CH4 production, 35 µmol·g−1 and 3.6 µmol·g−1, respectively. The composite also delivered the highest CO productivity (5.91 µmol·g−1·h−1), approximately 3.5 times that of pristine CZ, in addition to achieving the highest CH4 productivity (0.60 µmol·g−1·h−1). Furthermore, turnover frequency (TOF) analysis normalized per Cu site revealed that CuO incorporation not only enhances total productivity but also improves the intrinsic catalytic efficiency of the active copper centers. Overall, the synthesized composites demonstrate promising potential for CO2 photoreduction, driven by synergistic structural, electronic, and morphological features.
10 September 2026 in Journal of Solid State Electrochemistry
The rising levels of atmospheric CO₂ have exceeded the capacity of the natural carbon cycle, driving interest in electrocatalytic CO₂ reduction as an environmental and energy solution. Copper-based tandem electrocatalysts remain the most investigated catalysts due to their capability to convert CO₂ into a wide range of valuable products. However, such reactions require surface modulation to improve performance. Herein, we modulate the surface electrocatalyst via non-thermal N 2 and CO 2 plasma activation, yielding a well-coated CuO/Cu 2 O surface and creation of superficial defects that enhance electrocatalyst activity for CO 2 reduction to C 2+ products, with a faradaic efficiency greater than 70%, while suppressing hydrogen evolution. Our results demonstrate that CO 2 non-thermal plasma exposure to copper oxide nanostructures promotes greater roughness and creation of new active sites through oxygen vacancy defects, which play a partial role in determining catalytic performance, allowing stabilization of *CO intermediate, promoting the formation of C–C couple reaction and further conversion to C 3 products, we registered in potential − 1.2 V (vs. RHE) enhanced production of C 2+ , mostly acetic acid (35%), ethanol (20%), and propanol (10%). This plasma-assisted method improves CO 2 reduction reaction performance compared to that typically reported with a metallic copper substrate.