While p-type transparent conducting materials (TCMs) are crucial for many optoelectronic applications, their performance is still not satisfactory. This has impeded the development of many devices such as photovoltaics, sensors, and transparent electronics. Among the various p-type TCMs proposed so far, Cu-based oxides and oxychalcogenides have demonstrated promising results in terms of their optical and electrical properties. Hence, they are the focus of this current review. Their basic material properties, including their crystal structures, conduction mechanisms, and electronic structures will be covered, as well as their device applications. Also, the development of performance enhancement strategies including doping/co-doping, annealing, and other innovative ways to improve conductivity will be discussed in detail.
17 August 2022 in Journal of Materials Chemistry C
Currently, ultraviolet photodetectors attract extensive attention from people all over the world due to their applications in solar ultraviolet radiation detection, flame detection, ozone monitoring, missile tracking, and environmental monitoring. A heterojunction is an essential aspect for fulfilling the demand for high-performance self-powered ultraviolet photodetectors. However, it is still very challenging to achieve both good electrical property and transparency for p-type semiconductors and conductors especially at low preparation temperature. This work reports the fabrication of ultrathin, ultra-high-transparency and very smooth CuI films at room temperature by the copper film iodination method, whose figure of merit (FoM) far exceeds those of most of the typical p-type oxides. The obtained p-type CuI films (p-CuI) were fabricated on an n-type Si (n-Si) substrate to construct a heterojunction photodetector. The p-CuI/n-Si photodetector has excellent optoelectronic properties in self-powered mode, including a large responsivity and detectivity (123.3 mA W−1, 5.7 × 1012 Jones), and a fast response speed (rise/decay time of 90 μs/140 μs), which are overall better than those of all types of CuI-based self-powered photodetectors. In addition, the CuI film deposited on the flexible substrate was applied in a CuI photodetector with a metal–semiconductor–metal structure, exhibiting good optoelectronic properties and bending stability, which shows promising applications in transparent, flexible, wearable electronic and optoelectronic devices.
Metal–organic framework (MOF) films are essential for numerous sensor and device applications. However, metal-organic framework materials have poor machinability due to their predominant powder-like nature, and their presence as the active layer in a device can seriously affect the performance and utility of the device. Herein, active layers of field-effect transistor (FETs) devices and chemiresistor gas sensors with high performance were constructed by loading Cu3(HITP)2 (HITP = 2,3,6,7,10,11-hexaiminotriphenylene) in situ-axial anchoring on oriented nanofiber arrays prepared via electrospinning. The strong interaction between polar groups on the polymer chains and metal ions promotes the nucleation of Cu3(HITP)2, steric hindrance makes particles of Cu3(HITP)2 with uniform size, morphology, and good crystallinity during nucleation by liquid phase epitaxial growth (LPE). Influences of differently-oriented Cu3(HITP)2 NFAs-based FETs on the electrical properties were studied, optimally oriented Cu3(HITP)2 NFAs-based FETs showed good mobility of 5.09 cm2/V·s and on/off ratio of 9.6 × 103. Moreover, excellent gas sensing response characteristics were exhibited in sensing volatile organic compounds (VOCs). Chemiresistor gas sensors with high response value, faster response and recovery are widely suited for VOCs. It brings new inspirations for the design and utilization of electrically conductive MOFs as an active layer for FETs and sensor units for chemiresistor gas sensors.
29 June 2023 in ACS Applied Materials & Interfaces