This study presents a comprehensive evaluation of a novel spinneret design to enhance polymer melt extrusion performance in fibre spinning production. Computational fluid dynamics (CFD) simulations using ANSYS Polyflow 2024 R2 are employed to analyse flow behaviour, pressure distribution, and shear profiles within the die. The novel design demonstrates improved flow uniformity, reduced pressure fluctuations, and minimized high-shear regions compared to a baseline spinneret. Experimental validation is conducted through side-by-side extrusion tests using polypropylene and thermoplastic polyurethane, confirming the simulation results. Throughput efficiency tests further reveal that the novel spin pack design significantly reduces residence times by 16% and accelerates purging cycles, indicating fewer polymer stagnation zones and enhanced material changeover efficiency. The computational parametric study conducted on PP shows that the novel design demonstrates improved flow uniformity and a significant reduction in operating pressure, achieving an 11% decrease in die-head pressure compared to the baseline spinneret. Additionally, the optimized geometry successfully minimizes high-shear regions while maintaining a manageable maximum shear rate increase of approximately 19% at the walls, which aids in preventing wall slip. These enhancements lead to lower extrusion pressures and more consistent processing across various polymers. By minimizing material waste and improving process reliability, the new spinneret design contributes to a more sustainable, cost-effective manufacturing process. Overall, these improvements provide a valuable framework for advancing extrusion technologies and optimizing spinneret geometries for high-performance polymer extrusion. The novelty of this work lies in introducing a spinneret geometry specifically optimized to minimize melt residence time, an outcome directly linked to reduced material degradation and waste.
In this study, we produced UH‐PO sols using twin screw extrusion and characterized their thermal and rheological properties to evaluate changes induced by composition variation and extrusion process parameters. Extruder screw configuration, temperature profile, and UHMWPE mass fraction were varied, and the influence of N2 inert gas purge during processing was also assessed. Rheological measurements using parallel plate rheology served as a diagnostic tool to study the sol‐state viscoelastic behavior and to identify thermal‐mechanical and oxidative degradation, evident through changes in UHMWPE molar mass. Thermogravimetric analysis was employed to examine the extrudates' composition and solvent evaporation dynamics. The trials demonstrated the feasibility of increasing polymer concentration while maintaining proper sol and gel formation. Additionally, N2 gas tests highlighted that degradation of UH‐PO sols is predominantly oxygen‐driven, with inert gas purge showing significant protective effects, particularly at elevated temperatures. These findings underscore the potential of tuning process parameters to improve UHMWPE material properties while promoting cost efficiency and sustainability.