The detection and localization of leaks in water distribution networks (WDNs) is one of the major concerns of water utilities, due to the necessity of an efficient operation that satisfies the worldwide growing demand for water. There exists a wide range of methods, from equipment-based techniques that rely only on hardware devices to software-based methods that exploit models and algorithms as well. Model-based approaches provide an effective performance but rely on the availability of an hydraulic model of the WDN, while data-driven techniques only require measurements from the network operation but may produce less accurate results. This paper proposes two methodologies: a model-based approach that uses the hydraulic model of the network, as well as pressure and demand information; and a fully data-driven method based on graph interpolation and a new candidate selection criteria. Their complementary application was successfully applied to the Battle of the Leakage Detection and Isolation Methods (BattLeDIM) 2020 challenge, and the achieved results are presented in this paper to demonstrate the suitability of the methods.

This article presents a new data-driven method for locating leaks in water distribution networks (WDNs). It is triggered after a leak has been detected in the WDN. The proposed approach is based on the use of inlet pressure and flow measurements, other pressure measurements available at some selected inner nodes of the WDN, and the topological information of the network. A reduced-order model structure is used to calculate non-leak pressure estimations at sensed inner nodes. Residuals are generated using the comparison between these estimations and leak pressure measurements. In a leak scenario, it is possible to determine the relative incidence of a leak in a node by using the network topology and what it means to correlate the probable leaking nodes with the available residual information. Topological information and residual information can be integrated into a likelihood index used to determine the most probable leak node in the WDN at a given instant k or, through applying the Bayes’ rule, in a time horizon. The likelihood index is based on a new incidence factor that considers the most probable path of water from reservoirs to pressure sensors and potential leak nodes. In addition, a pressure sensor validation method based on pressure residuals that allows the detection of sensor faults is proposed.