In recent years, attention has been paid to wireless sensor networks (WSNs) applied to precision agriculture. However, few studies have compared the technologies of different communication standards in terms of topology and energy efficiency. This paper presents the design and implementation of the hardware and software of three WSNs with different technologies and topologies of wireless communication for tomato greenhouses in the Andean region of Ecuador, as well as the comparative study of the performance of each of them. Two companion papers describe the study of the dynamics of the energy consumption and of the monitored variables. Three WSNs were deployed, two of them with the IEEE 802.15.4 standard with star and mesh topologies (ZigBee and DigiMesh, respectively), and a third with the IEEE 802.11 standard with access point topology (WiFi). The measured variables were selected after investigation of the climatic conditions required for efficient tomato growth. The measurements for each variable could be displayed in real time using either a laboratory virtual instrument engineering workbench (LabVIEW) interface or an Android mobile application. The comparative study of the three networks made evident that the configuration of the DigiMesh network is the most complex for adding new nodes, due to its mesh topology. However, DigiMesh maintains the bit rate and prevents data loss by the location of the nodes as a function of crop height. It has been also shown that the WiFi network has better stability with larger precision in its measurements.
This paper focuses on the development of a virtual training system by applying simulation techniques such as: Full Simulation and Hardware-in-the-Loop (HIL). This virtual reality system is intended to be a teaching and learning tool focused on the area of industrial robotics. For this purpose, mathematical models (kinematic and dynamic) have been considered. These models determine the characteristics and restrictions of the movements of a Scara SR-800 robot. The robot is then virtualized to simulate position and trajectory tasks within virtual environments. The Unity 3D graphic engine (Unity Software Inc., San Francisco, CA, USA), allows the design and development of the training system which is composed of a laboratory environment and an industrial environment. The same that contribute to the visualization and evaluation of the movements of the robot through the proposed control algorithm using the mathematical software (MatLab, manufactured by MathWorks, USA), through shared memories. This software in turn can be linked to an electronic board (Raspberry Pi) for data acquisition through a wireless connection. Finally, the stability and robustness of the implemented controllers are analyzed, as well as the correct operation of the virtual training system.