Jiangong Zhou

Mr. Jiangong Zhou


Research Focus & Metrics

Academic Career Length

1Year (2026-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
3 January 2026 in Materials
Verified
Journal Article
Open access
PDF file
QWQunjiao Wang
Qunjiao Wang
MYMeilin Yin
Meilin Yin
JZJiangong Zhou
Jiangong Zhou
XLXinyu Liu
Xinyu Liu
HZHui Zhang
Hui Zhang
YZYunlong Zhang
Yunlong Zhang
This study presents a systematic numerical investigation into the ballistic performance of 7A52/7A62 aluminum alloy laminated plates with varying configurations. The dynamic mechanical behavior of the base alloys, 7A52 and 7A62, was first characterized experimentally, and the corresponding Johnson-Cook (J-C) constitutive parameters were calibrated. Using the calibrated J-C model, a series of numerical simulations were performed on several structural configurations, including single-layer (7A52-A, 7A62-B), double-layer (AB, BA), and four-layer laminates (ABAB, BAAB, ABBA, BABA). The results demonstrate that four-layer laminates exhibit markedly better ballistic performance than monolithic and double-layer plates. Among them, the ABAB stacking sequence—arranged in an alternating soft–hard–soft–hard pattern—shows the optimal performance, yielding a residual projectile velocity of only 256 m/s. This represents an approximately 27% reduction compared to the monolithic high-strength 7A62 plate. The overall ranking of ballistic performance is as follows: ABAB > BAAB > ABBA > BABA. Energy-based analysis further indicates that multi-interface delamination, coupled with plastic deformation and damage evolution, improves the energy-absorption efficiency of the laminated plates and thus enhances their ballistic resistance. This study offers valuable guidance for the lightweight design of laminated 7XXX-series aluminum alloy protective plates.

13 May 2026 in Materials
Verified
Journal Article
Open access
PDF file
QWQunjiao Wang
Qunjiao Wang
JZJiangong Zhou
Jiangong Zhou
DWDapeng Wang
Dapeng Wang
JMJun Miao
Jun Miao
CLChunming Liu
Chunming Liu
The effects of Ti/Nb microalloying-induced MC-type carbide precipitation and tempered microstructure evolution on the dry-sliding wear behavior of low-carbon martensitic wear-resistant steels were systematically investigated. Three experimental steels with different microalloying strategies (0.04Ti, 0.1Ti, and 0.04Ti/Nb) were subjected to quenching and subsequent tempering. Microstructural features, carbide characteristics, and mechanical properties were characterized using optical microscopy (OM), scanning electron microscopy (SEM), X-ray diffraction (XRD), transmission electron microscopy (TEM), tensile testing, and impact testing, while wear performance was evaluated by pin-on-disk tests under dry-sliding conditions. The results indicate that wear resistance is governed by the combined effects of tempered martensite stability and MC-type carbide precipitation. Low-temperature tempering effectively reduces the wear mass loss of Ti-containing steels by enhancing their resistance to abrasive shear deformation while maintaining sufficient toughness. In contrast, the Nb-containing steel exhibits a stage-dependent wear response associated with the formation and destabilization of oxide-derived third-body debris during sliding. (Nb,Ti)C precipitates act as microscale load-bearing units, contributing to strength enhancement and subsurface damage suppression, but their influence on wear behavior strongly depends on tempering temperature. The dominant wear mechanism is abrasive micro-cutting, accompanied by fatigue-induced spalling and oxidation-assisted damage at later stages. These results demonstrate that wear performance cannot be correlated with hardness alone, but instead requires the coordinated optimization of carbide precipitation and tempered microstructural stability. This work provides microstructural guidance for the design of microalloyed martensitic wear-resistant steels.