This study developed a simple, low-cost and industrially scalable method for collagen extraction from the skin of both cold and warm-water fishes while retaining the native triple-helical structure. Three fish species representing different skin compositions and different habitat temperatures: Tarakihi and Ling from New Zealand and Yellowfin tuna from Sri Lanka were selected to demonstrate its wide application to different raw materials. The method included extraction using hydrochloric acid to break cross-links while preserving the native triple-helical structure, homogenisation to speed-up the extraction and fibrillogenesis using sodium hydroxide to rapidly raise the pH to the isoelectric point. The effectiveness of this method was assessed by comparing collagen characteristics with a commercial biomedical-grade bovine collagen. The processing temperatures were well below the habitat temperatures, and fibrillogenesis at pH 9.3 resulted in higher yields of collagen with the retention of the native triple-helical structure as evidenced by FTIR absorption ratio, Rpn ratio from circular dichroism analysis and thermal properties by DSC. Higher denaturation temperatures of about 43 °C were recorded for collagen extracted from the skin of both cold and warm-water species when processed well below their habitat temperatures. This study showed the ability to process collagen from warm-water fish species at 19 °C, which saves energy at industrial-scale processing. This method employs a relatively few number of processing steps that omit complex centrifugation and dialysis techniques. This can be applied to any fish species of interest by adjusting processing conditions based on skin composition and habitat temperature. These developments represent promising factors for further commercial developments.
Fish skin, a by-product of commercial fish processing, represents a viable source of type I collagen. Acetic acid has been widely used for the extraction of collagen from fish skin because it can preserve the native structure. However, it requires an extraction time of more than 72 h and complex and time-consuming dialysis steps to remove acetic acid residues from the extracted collagen which can otherwise cause inferior structural modifications. Therefore, this study describes a simple time- and cost-effective method to extract collagen using hydrochloric acid. The experiments focused on understanding the behavior of fish skin and changes in the extraction medium. The extraction procedure developed in this study includes treatment with a 0.01 M hydrochloric acid solution at a 1:20 mass to volume ratio for 5 h, followed by homogenization. The native triple-helical structure of collagen was confirmed by ATR-FTIR and circular dichroism spectroscopy. Thermal stability was confirmed by differential scanning calorimetry. This study also provides guidelines for the application of this knowledge to skin of any fish species of interest: (i) an upper limit of pH 4 during collagen extraction; (ii) a manageable viscosity of the collagen extract solution; and (iii) as few undissolved skin pieces as possible after homogenization.
15 March 2026 in Sri Lanka Journal of Aquatic Sciences
A sheet face mask is a type of facial skincare cosmetic applied to the entire face to provide hydration, a refreshing sensation and skin tightening. A paradigm shift is now underway, fuelled by consumer concerns over the long-term safety of synthetic chemicals used in these products and the broader ecological footprint of cosmetic production. Consequently, κ-carrageenan is an alternative to these synthetic chemicals due to its natural origin, being free of harmful chemicals, gelling and hydration properties. The red seaweed, Kappaphycus alvarezii, the only seaweed species commercially cultivated in Sri Lanka is a rich source of κ-carrageenan, however, it has not yet been used locally to extract carrageenan and test its application in skincare cosmetics. Precipitation of κ-carrageenan using KCl is a critical step in carrageenan extraction process as it imparts strength to carrageenan gels. In this study, carrageenan was extracted using three concentrations of KCl and its suitability for a sheet face mask gel was tested across three carrageenan concentrations. The results showed that comparatively higher yields of 31.89±0.05 and 33.52±2.50 were obtained at 2.50% and 3.50% KCl concentrations, respectively. All tested characteristics for a leave-on sheet face mask gel were achieved at 1.00% carrageenan concentration prepared using carrageenan extracted at 3.50% KCl concentration. Notably, prepared carrageenan gels were able to moisturise the skin without altering skin oiliness.