Seiya Nitta

Mr. Seiya Nitta


Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
20 October 2023 in Applied Sciences
Verified
Journal Article
Open access
PDF file
NONorimitsu Okuyama
Norimitsu Okuyama
KNKazufumi Nomura
Kazufumi Nomura
Tomokazu SanoTomokazu Sano
Tomokazu Sano
KKKeiji Kadota
Keiji Kadota
SNSeiya Nitta
Seiya Nitta
SASatoru Asai
Satoru Asai
Blowholes caused by vaporization of the galvanized layer are a problem with galvanized steel sheets, which use lap joint welding. The laser ultrasonic method is the possible solution to realize the desirable 100% inspection instead of the conventional sampling inspection. We have previously proposed a method to detect blowholes by capturing the reduction in ultrasonic intensity when it passes through internal defects through signal processing. However, there was a problem that the detection indicator devised varied. In this study, we investigated the causes and trends of detectability using finite element analysis. To efficiently calculate the results obtained by scanning measurement, we proposed and established a method to reproduce the results by taking the results from static measurements, which were shifted in the direction of the weld line little by little. As a result, it was found that one of the reasons for the detection indicator variation with scanning by the lasers is the three-dimensional positional relationship between the blowhole and the scanning measurement line. In addition, it was possible to propose the performance required for the ultrasonic generation laser such as the traveling speed and the repetition frequency by back-calculating the spatial resolution from the rate of detection needed.

26 December 2025 in Applied Sciences
Verified
Journal Article
Open access
PDF file
SNSeiya Nitta
Seiya Nitta
KKKeiji Kadota
Keiji Kadota
KNKazufumi Nomura
Kazufumi Nomura
TETetsuo Era
Tetsuo Era
SASatoru Asai
Satoru Asai
Assurance of the integrity of every weld joint is highly desirable, and defect detection methods that can be applied to welds at high temperatures immediately after welding are required. The laser ultrasonic (LU) method, which generates ultrasonic waves in the target via pulsed laser irradiation, is a well-known technique for non-contact defect detection during welding. Ultrasonic waves excited in ablation mode exhibit large amplitudes and predominantly surface-normal propagation, which has driven extensive research into their application for weld inspection. However, owing to the size and weight of conventional equipment, such systems have largely been limited to bench-top experimental setups. To address this, we developed an LU robotic system incorporating a compact, lightweight laser source and an improved signal-processing system. We conducted experiments to measure signals and to detect backside slits in flat plates and blowholes in lap-fillet welds. Additionally, a method to improve the sensitivity of laser interferometers was investigated and demonstrated on smut-covered areas near weld beads.