Rotating bending fatigue tests were carried out by using the 7075-T7351 Al alloy with a microarc oxidation (MAO) coating (h = 10 μm) and with no coating. Tests were conducted in air and 5.0% NaCl aqueous solution conditions. The fatigue microscopic fracture behavior of the metals was investigated by using scanning electron microscope and three-dimensional digital microscope technologies. The empirical formulas between the stress intensity factor ΔK and the fatigue life Nf in the different conditions were obtained. In addition, the reason for data scattering in the fatigue lives of uncoated 7075-T7351 samples under the same stress amplitude in air was analyzed. Furthermore, the fatigue characteristic life of 7075-T7351 alloy was predicted by the three-parameter Weibull distribution model.
The low cycle fatigue tests on the crack initiation and propagation of cast magnesium alloys with two small holes were carried out by using in-situ scanning electron microscope (SEM) observation technology. The fatigue crack propagation behaviors and fatigue life, which are affected by two small artificial through holes, including the distances between two holes and their locations, were discussed in detail based on the experimental results and the finite element analysis (FEA). The results indicated that the fatigue multi-cracks occurred chiefly at the edges of two holes and the main crack propagation was along the weak dendrite boundary with the plastic deformation vestiges on the surface of α-Mg phase of cast AM50 and AM60B alloys. The fatigue cracking characteristics of cast AZ91 alloy depended mainly on the brittle properties of β-Mg17Al12 phase, in which the multi-cracks occurred still at the edges of two holes and boundaries of β-Mg17Al12 phase. The fatigue crack initiation position of cast magnesium alloys depends strongly on the radius of curvature of through hole or stress concentration factor at the closed edges of two through holes. In addition, the fatigue multi-cracks were amalgamated for the samples with titled 45° of two small holes of cast Mg-Al alloys when the hole distance is less than 4D (D is the diameter of the small hole).