We present a magnetic domain-imaging study by x-ray magnetic circular dichroism photoelectron emission microscopy on a bilayer under exposure to single focused ultrashort (100 fs) infrared laser pulses. Magnetic domain walls experience a force in the intensity gradient of the laser pulses away from the center of the pulse, which can be used to steer domain walls to move in a certain direction. Maximum domain-wall displacements after individual laser pulses close to in zero external field are observed. Quantitative estimates show that electronic spin currents from the spin-dependent Seebeck effect are not strong enough to explain the effect, which we thus attribute to the torque exerted by magnons from the spin Seebeck effect that are reflected at the domain wall.
We present a microscopic investigation of how the magnetic domain structure in ultrathin films changes after direct excitation by single ultrashort laser pulses. Using photoelectron emission microscopy in combination with x-ray magnetic circular dichroism in the resonant absorption of soft x rays, we find that individual laser pulses of duration and a central wavelength of lead to clear changes in the domain structure of a Co layer of three atomic monolayers thickness in an epitaxial Co/Cu/Ni trilayer on a Cu(001) single-crystal substrate. A relatively small enhancement of the sample base temperature by 40 K is sufficient to lower the threshold of laser fluence for domain wall motion by about a factor of two. Pump-probe measurements with a laser fluence just below this threshold indicate that the laser-induced demagnetization of the sample is far from complete in these experiments. Although the domain wall motion appears similar to thermal domain wall fluctuations, quantitatively it cannot be explained by pure thermal activation of domain wall motion by the transient rise of sample temperature after the laser pulse, but it is likely to be triggered by a laser-induced depinning of domain walls.
The influence of the antiferromagnetic (AFM) spin structure of epitaxial films on the magnetic properties of adjacent out-of-plane-magnetized ferromagnetic (FM) Ni layers in trilayers on Cu(001) is investigated by magneto-optical Kerr-effect experiments. An AFM interlayer coupling between the two FM layers, which emerges below the AFM ordering temperature for an odd number of atomic layers of the antiferromagnet, suddenly disappears at a lower, AFM-thickness-dependent transition temperature. For even numbers of atomic layers of the antiferromagnet, a maximum of the coercivity is observed at a corresponding temperature. This result is interpreted as a transition of the AFM spin structure of the layer that strongly affects the interlayer exchange coupling of the two FM layers by direct exchange through the AFM layer.
We investigated the magnetic interlayer coupling between two ferromagnetic (FM) Ni layers through an antiferromagnetic (AFM) Ni25Mn75 layer and the influence of this coupling on the exchange bias phenomenon. The interlayer coupling energy of an epitaxial trilayer of 14 atomic monolayers (ML) Ni/45 ML Ni25Mn75/16 ML Ni on Cu3Au(001) was extracted from minor-loop magnetization measurements using in-situ magneto-optical Kerr effect. The interlayer coupling changes from ferromagnetic to antiferromagnetic when the temperature is increased above 300 K. This sign change is interpreted as the result of the competition between an antiparallel Ruderman-Kittel-Kasuya-Yosida (RKKY)-type interlayer coupling, which dominates at high temperature, and a stronger direct exchange coupling across the AFM layer, which is present only below the Néel temperature of the AFM layer.
15 February 2014 in Journal of Magnetism and Magnetic Materials
The growth, morphology, and structure of films on Cu(001) and Ag(001) are studied by means of low‐energy electron diffraction (LEED), medium‐energy electron diffraction, Auger electron spectroscopy, and scanning tunnelling microscopy. Different concentrations x from about 0.5 to 1 and thicknesses from 0.2 to 12.9 ML of are examined. For several values of x, exhibits a c(2 2) superstructure pattern on Cu(001) when the total thickness is around or above 0.5 ML. Above 1 ML, LEED patterns of can be only observed on Ag(001), but not on Cu(001). LEED‐I(V) is employed to deduce the vertical interlayer distance for as‐grown and post‐annealed films on Ag(001). Above 500 K, Ag from the substrate segregates into the films.