HfO2 films have become a critical component for advanced electronics and a wide range of applications. However, their implementation requires control of their microstructure and defects, which often act as charge carrier traps, leading to leakage current in devices and hindering their dielectric properties. Here, we deposit HfO2 thin films by atomic layer deposition (ALD) on sapphire, Ga2O3, and InGaO3 substrates at low temperature and investigate the dependence of their crystal structure on substrate type, annealing, and thickness. X-ray diffraction measurements showed that alloying Ga2O3 with a modest amount of Indium transferred HfO2 films from amorphous to polycrystalline, an important finding that may be applicable to the deposition of other material systems. The study also presents an interesting approach to measuring shallow and deep traps formed in the films and shows how to control their levels and distributions in the band gap. The measurements reveal that the difference in band gap between the substrate and film, as well as the presence of impurities, strongly influences trap densities and depths. Electron paramagnetic resonance (EPR) measurements were performed to probe the electronic structure of specific point defects detectable by EPR and to correlate these results with trap measurements.
Ga2O3 and In2O3 are vital semiconductors with current and future electronic device applications. Here, we study the alloying of In2O3 and Ga2O3 (IGO) and the associated changes in structure, morphology, band gap, and electrical transport properties. Undoped films of IGO were deposited on sapphire substrates with varying indium (In) percentage from zero to 100% by metal-organic chemical vapor deposition (MOCVD). Some films were annealed in H2 to induce electrical conductivity. The measurements showed the optical band gap decreased by adding In; this was confirmed by density functional (DFT) calculations, which revealed that the nature of the valence band maximum and conduction band minimum strongly relate to the chemistry and that the band gap drops by adding In. The as-grown films were highly resistive except for pure In2O3, which possesses p-type conductivity, likely arising from In vacancy-related acceptor states. N-type conductivity was induced in all films after H-anneal. DFT calculations revealed that the presence of In decreases the electron effective mass, which is consistent with the electrical transport measurements that showed higher electron mobility for higher In percentage. The work revealed the successful band gap engineering of IGO and the modification of its band structure while maintaining high-quality films by MOCVD.