Additive manufacturing has enabled a transformational ability to create cellular structures (or foams) with tailored topology. Compared to their monolithic polymer counterparts, cellular structures are potentially suitable for systems requiring materials with high specific energy-absorbing capability to provide enhanced damping. In this work, we demonstrate the utility of controlling unit-cell topology with the intent of obtaining a desired stress–strain response and energy density. Using mesoscale simulations that resolve the unit-cell sub-structures, we validate the role of unit-cell topology in selectively activating a buckling mode and thereby modulating the characteristic stress–strain response. Simulations incorporate a linear viscoelastic constitutive model and a hyperelastic model for simulating large deformation of the polymer under both tension and compression. Simulated results for nine different cellular structures are compared with experimental data to gain insights into three different modes of buckling and the corresponding stress–strain response.
19 September 2024 in Computer Methods in Applied Mechanics and Engineering
Due to its ability to achieve geometric complexity at high resolution and low length scales, additive manufacturing (AM) has increasingly been used for fabricating cellular structures (e.g., foams and lattices) for a variety of applications. Specifically, elastomeric cellular structures offer tunability of compliance as well as energy absorption and dissipation characteristics. However, there are limited data available on compression properties for printed elastomeric cellular structures of different designs and testing parameters. In this work, the authors evaluate how unit cell topology, part size, the rate of compression, and aging affect the compressive response of polyurethane-based simple cubic, body-centered, and gyroid structures formed by vat photopolymerization AM. Finite element simulations incorporating hyperelastic and viscoelastic models were used to describe the data, and the simulated results compared well with the experimental data. Of the designs tested, only the parts with the body-centered unit cell exhibited differences in stress–strain responses at different part sizes. Of the compression rates tested, the highest displacement rate (1000 mm/min) often caused stiffer compressive behavior, indicating deviation from the quasi-static assumption and approaching the intermediate rate response. The cellular structures did not change in compression properties across five weeks of aging time, which is desirable for cushioning applications. This work advances knowledge on the structure–property relationships of printed elastomeric cellular materials, which will enable more predictable compressive properties that can be traced to specific unit cell designs.