Metal-oxide surge arresters (MOSAs) are critical devices for overvoltage protection in power systems, and the aging characteristics of their zinc oxide (ZnO) varistors under impulse and power-frequency voltages exhibit significant differences. However, traditional methods for monitoring the aging state of surge arresters suffer from limitations such as insufficient sensitivity and vulnerability to harmonic interference. Therefore, this study conducted accelerated aging experiments on ZnO varistor samples under negative-polarity impulse currents. Key parameters were measured, including the DC reference voltage, the DC leakage current, nonlinear coefficients, and the full current under harmonic-containing power-frequency voltage at a voltage ratio of 0.6. The resistive component was accurately extracted from the full current using a separation method based on the Levenberg–Marquardt (LM) optimization algorithm. Spectral analysis was then performed on both the full current and the extracted resistive current components. The experimental results demonstrate a significant polarity effect in the aging of ZnO varistors under unipolar impulse currents. The LM optimization algorithm enables precise extraction of the resistive current component from the full current. Furthermore, compared to the fundamental and third harmonic components, the amplitude of the DC component within the resistive current exhibits the highest sensitivity to aging, establishing it as a viable aging criterion.
Surface charge accumulation and trap distribution are the core factors affecting the surface flashover characteristics of insulating materials. Considering the low-temperature gradient environment of superconducting energy pipeline terminations, this paper systematically studies the surface charge dynamic characteristics and trap distribution law of epoxy glass fiber (GFRP) by using the isothermal surface potential decay (ISPD) method combined with finite element simulation. A temperature-controlled ISPD test platform of −30~20 °C (193~293 K) was built to measure the surface potential decay curves at different temperatures and calculate the trap energy level and density; a charge migration model considering temperature gradient was established to analyze the influence of trapped charges on surface potential and electric field distribution. The results show that low temperature significantly reduces the surface potential decay rate (the residual potential after 5000 s is 92.91% of the initial value at 193 K, and only 3.51% at 293 K); the traps of GFRP at 193 K are dominated by deep traps (central energy level 0.68 eV, density 1.63 × 1020 m−3·eV), while there is a bimodal distribution of shallow traps (0.92 eV) and deep traps (0.98 eV) at 293 K; under temperature gradient, the accumulation of deep trap charges in the low-temperature region leads to a surface electric field distortion rate of 12.60, which is the key microscopic mechanism for the decrease of flashover voltage.