Wasakorn Traiphat

Mr. Wasakorn Traiphat

orcid

Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
19 January 2023 in EUREKA: Physics and Engineering
Verified
Journal Article
Open access
PDF file
WNWichai Wichai Nramat
Wichai Wichai Nramat
WTWasakorn Traiphat
Wasakorn Traiphat
PSPhuachat Sukruan
Phuachat Sukruan
PUPrachum Utaprom
Prachum Utaprom
STSaranyaras Tongsawai
Saranyaras Tongsawai
SSSuvinai Sodajaroen
Suvinai Sodajaroen
This article presents the development of a model center using agricultural intelligent center technology. The goal of this research is 1. To develop a wireless sensor network. 2. To be a source of learning on the use of sensor technology in agriculture. For local and nearby farmers Using the Sufficiency Economy Learning Center, according to King's Science. The Rajamangala University of Technology Suvarnabhumi is a research area. With the problems faced in farming today. It found that the world's climate change whether it's drought. Rains leave ranges and toxic airborne particulate matter caused by farming to match current problem conditions. The researchers then designed a two-part system: 1. Node Moisture Sensor that measures soil moisture and commands the opening – It also controls on-off with a manual switch. Wind speed and wind direction sensors, light intensity sensors, temperature, and humidity sensors, and Particulate Matters Sensor 1.0, 2.5, 10 with environmental reports within the growing area via Wi-F signals to (Sever) Raspberry Pi record real-time data. Every 30 seconds According to research, node moisture sensors can measure soil moisture and record results, and the station measures the environment within the growing area via a Wi-F signal to (Sever) Raspberry Pi. Rainfall values measured by local rainfall sensors measuring up to 35.3 mm are within the threshold of heavy rain. The maximum wind speed measured is 8.5 km/h, the maximum temperature of 35.8 degrees Celsius, and the maximum humidity of 99.9 percent, the light intensity is up to 58,002 Lux, and the Final Particles, with pm 1.0 up to 40.1 microns, PM 2.5 up to 51.3 microns and PM 10 up to 63.5 microns. Apply agriculture to 50 interested farmers after receiving knowledge transfer of smart sensor technology. The expansion has resulted in 3 farmers and will continue to expand in the future. Promote the use of agricultural technology. Intensifying communities and supporting global climate change

11 February 2026 in Eng
Verified
Journal Article
Open access
PDF file
WNWichai Wichai Nramat
Wichai Wichai Nramat
ESEkawit - Songkrohb
Ekawit - Songkrohb
PBPatiwat - boonmac
Patiwat - boonmac
WTWasakorn Traiphat
Wasakorn Traiphat
Ekkachai MartwongEkkachai Martwong
Ekkachai Martwong
Ongard ThiabgohOngard Thiabgoh
Ongard Thiabgoh
This study presents a low-cost wireless sensor network (WSN) integrated with an Internet of Things (IoT) platform for continuous monitoring of agro-environmental parameters relevant to rice harvest decision support. Solar-powered sensor nodes equipped with temperature-humidity (DHT22) and light intensity (BH1750) sensors were deployed in a Pathum Thani 1 rice field in Si Prachan, Suphan Buri province, Thailand. Environmental data were recorded hourly from June to September 2025 and transmitted wirelessly to a cloud-based dashboard for real-time visualization. Growing Degree Days (GDD) were calculated from measured air temperature using a literature-based base temperature, and cumulative GDD (CGDD) was used to track rice growth progression across vegetative, reproductive, and grain-filling stages. The system demonstrated stable long-term operation and continuous data acquisition under field conditions. Observed CGDD trends were consistent with reported growth-stage thresholds for the studied rice variety, while measured light intensities ranged from 36,900 to 37,810 lx, relative humidity remained consistently high throughout the season, and air temperatures varied between daily minima of 23.5–25.2 °C and maxima near 35.4 °C, which are suitable for rice photosynthesis and development. The seasonal CGDD increased linearly to 580.3, 1189.9, 1593.7, and 2385.7 °C by the end of June, July, August, and September, respectively, exhibiting a strong linear relationship with days after 1 June 2025 (R2 = 0.9999), which confirms stable thermal accumulation throughout the growing season.

1 February 2026 in Eng
Verified
Journal Article
Open access
PDF file
WNWichai Wichai Nramat
Wichai Wichai Nramat
WTWasakorn Traiphat
Wasakorn Traiphat
Ekkachai MartwongEkkachai Martwong
Ekkachai Martwong
PTPatcha Treemongkol
Patcha Treemongkol
LPLuedate Phatedoung
Luedate Phatedoung
Ongard ThiabgohOngard Thiabgoh
Ongard Thiabgoh
This study presents the design, fabrication, and performance evaluation of a solar dryer capsule cabinet equipped with a parabola reflector, developed to enhance drying efficiency through the reflection of sunlight onto both the upper and lower surfaces of the product. Conventional solar drying exposes only the upper surface, resulting in uneven heating and the need for manual turning. The proposed system integrates a parabolic reflector and IoT-based monitoring sensors (BH1750 light sensor and DHT22 temperature-humidity sensor) to optimize heat distribution and record real-time environmental parameters. Dry experiments were conducted using Citrus hystrix DC. (Makrut lime) peels under natural sunlight from 9:00 a.m. to 5:00 p.m. The moisture loss achieved with the proposed dryer (P-DSD) was 45.66%, compared with 6.79% for direct solar drying (DSD). The drying rate increased from 3.05 g h−1 (DSD) to 20.50 g h−1 (P-DSD), while the specific energy consumption (SEC) decreased from 3519.75 kWh kg−1 to 523.67 kWh kg−1, representing an 85.13% energy reduction. Economic analysis showed a system cost of $1384 and a return on investment of 30.0%. These results demonstrate that the proposed solar dryer capsule cabinet with a parabola reflector offers a low-cost, eco-friendly, and high-efficiency solution for drying agricultural and herbal products, significantly shortening the drying time and improving product quality.

5 June 2026 in Sustainability
Verified
Journal Article
Open access
PDF file
WNWichai Wichai Nramat
Wichai Wichai Nramat
PTPatcha Treemongkol
Patcha Treemongkol
WTWasakorn Traiphat
Wasakorn Traiphat
Ongard ThiabgohOngard Thiabgoh
Ongard Thiabgoh
Ekkachai MartwongEkkachai Martwong
Ekkachai Martwong
Greenhouse vegetable cultivation in tropical regions is often affected by high temperature, unstable humidity, and irrigation management problems. This study presents a pilot-scale case study of Green Oak lettuce cultivation using an IoT-based sensor monitoring and automated irrigation control system in Phra Nakhon Si Ayutthaya Province, Thailand. The system used AM2315C, BH1750, NPK, and flow sensors connected to ESP32. Data were transmitted to the ThingsBoard platform for real-time environmental monitoring and irrigation control. The greenhouse temperature averaged 33.21 ± 3.61 °C, while relative humidity averaged 71.55 ± 9.66%. The average daytime light intensity was 16,976 ± 409 lux. Nitrogen (N), phosphorus (P), and potassium (K) concentrations remained within ranges of 62.42–74.57, 76.46–84.30, and 71.46–79.30 mg/kg, respectively. Economic evaluation demonstrated favorable feasibility, with a water use efficiency (WUE) of 0.63 kg/L, return on investment (ROI) of 40%, benefit–cost ratio (BCR) of 1.6, and payback period of approximately 2.5 years. The developed system demonstrates potential for supporting sustainable greenhouse agriculture and contributes to SDG 2, SDG 6, SDG 12, and SDG 13 under tropical agricultural conditions.

28 November 2024 in EUREKA: Physics and Engineering
Verified
Journal Article
Open access
PDF file
WNWichai Wichai Nramat
Wichai Wichai Nramat
WTWasakorn Traiphat
Wasakorn Traiphat
PSPhuachat Sukruan
Phuachat Sukruan
PUPrachum Utaprom
Prachum Utaprom
LPLuedate Phatedoung
Luedate Phatedoung
SNSutep Nramat
Sutep Nramat
This article presents the development of drying Andrographis paniculata with hot air controlled by artificial intelligence system together with infrared rays. The tools used in the research are Andrographis paniculata drying cabinet with hot air controlled by artificial intelligence system together with infrared rays. The part consists of an oven with a width of 1204 millimeters and a length of 380 millimeters. A 65-watt blower fan serves to blow air to move heat evenly into the dryer. The source of heat release uses a heating coil, Fin Heater/fin heater. Voltage size 220 V 1,000 W, length 450 mm, metal weave size 11 mm, fin size 31 mm. Heat with a thermocouple was checked to compare with the temperature set. In the event that the temperature in the Andrographis paniculata dryer has not decreased, the thermal camera will turn on the ventilation fan to carry the heat outside. and ordered to reduce the temperature of the heater. The measured temperature data will be saved to the Raspberry Pi server. Research found that the machine can dry Andrographis paniculata according to the machine's operating conditions. And can dry Andrographis paniculata at a temperature of 40 °C according to the value specified in drying. The humidity before drying was 100 % and after drying – 0.73 %. The weight before drying was – 30g and after drying – 8.1g. The drying rate was 1.37 and the average temperature – 60 °C according to the value specified in drying. Moisture before drying was 100 % and after drying – 0.79 %. Weight before drying was 60g and after drying – 12.6g. Drying rate was 1.27. The system also uses a low heat source with a power of 1 kW. Electrical voltage – 220 V

31 January 2025 in EUREKA: Physics and Engineering
Verified
Journal Article
Open access
PDF file
WTWasakorn Traiphat
Wasakorn Traiphat
WNWichai Wichai Nramat
Wichai Wichai Nramat
PSPhuachat Sukruan
Phuachat Sukruan
PUPrachum Utaprom
Prachum Utaprom
PPPitichon Piamboriboon
Pitichon Piamboriboon
SNSutep Naramat
Sutep Naramat
This article experiments comparing the efficiency between watering vegetable crops with traditional methods and automatic watering systems. Objectives: 1. To study the operation of sensors, including temperature and relative humidity sensors and soil moisture sensors. 2. To compare the conventional irrigation of crops with automatic irrigation and to assess the satisfaction of 5 farmers. This is to be used as information to support farmers' decisions. In smart agriculture that is on the rise around the world. Install 1 Relative Temperature and Humidity Sensor (AM2315 I2C) to measure air temperature and humidity values converted into digital signals. Transmit via Wi-Fi signal to the WeMos Arduno UNoR3+ microcontroller ESP8266, and 1 capacitive moisture sensor that sends an analog signal to the WeMos Arduno UNoR3+ESP8266 microcontroller. Experiments are carried out in greenhouses for growing vegetables measuring 6x3 meters. Results: 1. Automatic irrigation of the house with sensors. By experimenting with growing white cabbage, it was found that the temperature control was at an average of 37 degrees Celsius. Average relative humidity inside greenhouses 52.3 %, average soil moisture retention 55 %. 2. The results of the questionnaire of 5 farmers showed that the conventional irrigation of crops had an average value of 1.68 and an S.D value of 0.42. Irrigation with automation. The average value is 4.84 and the S.D value is 0.29, which shows that the irrigation system is automated. Efficient work shortening the working time can solve the problem of changing global climate conditions. This makes it easy for farmers to make decisions when choosing to use the automation system.