The demand for sustainable and environmentally friendly soil stabilization methods for subgrade improvement for pavements has led to exploring techniques that minimize ecological impact while optimizing engineering properties. Traditional stabilizers like cement and lime, though effective, have significant environmental drawbacks, including a high carbon footprint, disruption of vegetation, and health risks to workers. This study investigates the efficiency of biopolymers and eggshell powder as eco-friendly, sustainable soil stabilization agents. Parameters such as compaction characteristics, California Bearing Ratio (CBR), and micro-structural analysis were assessed. The research evaluates soil samples treated with varying concentrations of biopolymer (1%, 2%, and 3%) and eggshell powder (4%, 6%, and 8%). Results indicated that biopolymer addition slightly decreased the maximum dry density (MDD) and increased the optimum moisture content (OMC), while eggshell powder slightly increased MDD and decreased OMC. The optimal mix, soil + 1% xantham gum + 6% eggshell powder, enhanced CBR by 225.6% and 323.8% for soaked and unsoaked conditions, respectively. The scanning electron microscope revealed that treated soil samples transformed into a hard solid matrix, demonstrating improved stability. EDX analysis revealed the mineralogical composition of the mixes. Overall, the use of biopolymers and eggshell powder not only enhances soil strength but also promotes environmental sustainability.
13 October 2025 in Journal of Taibah University for Science
Most of the soil found has very little strength. There are different methods of stabilising and increasing the strength of the parent soil, such as the addition of chemicals or additives. One of the emerging methods is Microbial Induced Calcite Precipitation (MICP). This MICP technique is an eco-friendly advanced technology used for soil stabilising by using microorganisms, i.e. bacteria. The microbial activities are responsible for the change in the properties of the soil. Different studies have been conducted, and different laboratory tests have been performed to analyse the effect of MICP technology on the soil. It is seen that there is the formation of calcium carbonate precipitate which is responsible for the change in the soil parameter. The formation of Calcium carbonate intact the soil particles decreases the voids and increases the friction, stability and strength of the soil. However, the application of MICP is still very rare as very few studies have been done on this topic. This paper reviews the MICP techniques in detail, the strength mechanism, factors that need to be considered while adopting these techniques, the different procedures and approaches followed by the researchers and the change in the soil properties that stabilise the soil.
Clayey soils have low strength, high compressibility, and large reductions in their bearing capacity after exposure to moisture, thus not being appropriate for engineering applications such as pavements and foundations. The conventional methods are expensive and damages the environment. Therefore, sustainable and eco-friendly alternatives are needed to mitigate the problem. The present study aims to investigate the potential of bio-mediated stabilization using bacterial solution (BS) and guar gum (GG) biopolymer to improve the mechanical properties of clayey soils. To assess the efficiency of the stabilization process, a wide range of experimental investigations was conducted using triaxial compression tests and California Bearing Ratio (CBR) tests under different curing conditions. Various percentages of bacterial solution (0.5%, 1.0%, and 1.5%) and guar gum (0.5%, 1.0%, 1.5%, and 2.5%) were used to assess their individual and synergistic effects on the shear strength properties of the soils. The results of the triaxial test showed that the deviatoric stress and shear strength parameters of the soils treated using the bacterial solution and guar gum showed a significant improvement when compared to the untreated soil. The results showed that the mixture containing 1.0 BS and 0.5% GG revealed the highest improvement, where the maximum deviatoric stress values of 511 kPa, 688 kPa, and 861 kPa were achieved at different confining pressures of 50 kPa, 100 kPa, and 150 kPa, respectively. For the untreated soil, the CBR values of 2.71% and 0.76% were obtained in the unsoaked and soaked test conditions, respectively. This revealed poor subgrade stability. In contrast, the results obtained from the combined stabilization technique showed remarkable improvement in the CBR values. For the optimum mixture of 1.0 BS + 0.5% GG, the highest unsoaked CBR value of 16.24% and soaked CBR value of 14.22% were obtained at the end of 7 days of curing, which revealed approximately six-fold and eighteen-fold improvement over the CBR values of the untreated soils. The application of bacterial solution and guar gum biopolymer results in an improvement in the shear strength behaviour and load-carrying capacity of the clayey soil. The improvement in the soil is attributed to the formation of calcium carbonate bonds as a result of microbial action and the formation of a biopolymer network revelled in microstructural analysis, which increases the soil strength.