Flax (Linum usitatissimum L.) is a crop widely cultivated for fiber and oil production. The screening method for flax breeding must effectively address the biochemical characteristics of flaxseeds. In this study, to characterize flax cultivars, we extracted oil, defatted kernel, hull, and mucilage from whole seeds for the ATR-FT-MIR and FT-Raman spectroscopic measurements. In addition, for ATR-FT-MIR analysis, oil samples were obtained by pressing the flaxseed directly onto the crystal surface. After removing any seed residues, a grease stain was used for the measurement, allowing for the acquisition of the oil spectrum from a single seed. This method also enabled the detection of free fatty acids, serving as evidence of seed damage. Both methods effectively estimated the degree of unsaturation as a cultivar marker. The vibrational spectra of defatted kernels showed strong protein features; polysaccharide bands dominated in hull and mucilage spectra. Discrimination of flax cultivars using principal component analysis of vibrational spectra in specific regions was the most promising for flaxseed oil and mucilage. Multivariate analysis of a set of selected variables sensitive to the flaxseed oil composition successfully distinguished all flax cultivars of this study. The strong correlation observed between ATR-FT-MIR and FT-Raman results confirmed that these methods are comparable for characterizing different grades of flaxseed oil.

The demand for clean-label functional foods has increased interest in natural polysaccharides with health benefits. Acemannan, an O-acetylated glucomannan from Aloe vera, possesses antioxidant, immunomodulatory, and prebiotic activities, but its performance in fat-based systems is not well understood. This study examined the incorporation of acemannan into dark chocolate at 1% and 5% (w/w) and its effects on physicochemical, rheological, antioxidant, and sensory properties. Particle size distribution remained within acceptable limits, though the 5% sample showed a larger mean size and broader span. Rheological tests confirmed shear-thinning behavior, with the higher concentration increasing viscosity at low shear and reducing it at high shear. Antioxidant activity measured by the DPPH assay showed modest improvement in enriched samples. Consumer tests with 30 panelists indicated a strong preference (89%) for the 1% formulation, which maintained a smooth mouthfeel and balanced sensory characteristics, while the 5% sample displayed more fruity and earthy notes with lower acceptance. GC–MS analysis revealed altered volatile profiles, and FTIR spectroscopy confirmed acemannan stability in the chocolate matrix. These findings demonstrate that acemannan can be incorporated into dark chocolate up to 1% as a multifunctional, structurally stable polysaccharide ingredient without compromising product quality.

This study explores substituting sucrose with a binary polyol blend (sorbitol and mannitol) in muffin formulations to create a sugar-reduced alternative without compromising quality. Five formulations were tested: a 100% sucrose control (F1), partial substitutions (F2-F4), and a total replacement with a 1:1 mannitol-sorbitol blend (F5). Results showed that higher polyol concentrations (F4 and F5) improved moisture retention (37.2% and 36.4%, respectively) compared to the control. While water activity decreased in F1-F4 to 0.87 after 48 hours, F5 stabilized at 0.88. Microbiological analysis confirmed all samples were safe, with F5 showing the lowest total plate count (1100 CFU/g). Sensory evaluation indicated that while F5 was paler and stickier, partial substitutions (F3 and F4) excelled in aroma and overall impression. A 35% mannitol and 15% sorbitol blend optimize nutritional reduction, safety, and consumer appeal, offering a scalable strategy for healthier foods.