This study investigates the reliability of Francis turbines and highlights the critical need for an improved deformation monitoring system for bolts that fasten a hydroturbine head-cover to its casing. During different operational stages of the hydraulic unit, such as start-up, partial load, and full load, the hydroturbine head-cover and its fastening bolts are subjected to static and cyclic loads. The loads generate vibrations and different deformations that must be monitored. Although various measuring instruments, such as vibration sensors and accelerometers, have been developed to monitor hydroturbine vibrations, only two systems—KM-Delta-8-CM and PTK KM-Delta—are currently applied to measure fastening bolt deformation. Furthermore, only one system, SKDS-SISH, was found to monitor the forces inducing this deformation. After analysis, it is evident that the described systems for monitoring the deformation of the fastening bolts do not guarantee the trustworthiness of the measuring sensors and there is a need for their improvement. The implementation of a self-checking function (including metrological features), the development of a digital twin of the sensor, and the application of technologies based on artificial intelligence could solve this problem.
This study proposes an analytical redundancy method that combines empirical models with a Kalman filter to ensure the reliability of measurements from axial deformation sensors in a turbine head-cover bolt-monitoring system. This integration enables the development of predictive models that optimally estimate the dynamic deformation of each bolt during turbine operation at full and partial load. The test results of the models under conditions of outliers, measurement noise, and changes in turbine operating mode, evaluated using accuracy and sensitivity metrics, confirmed their high accuracy (Acc ≈ 0.146 µm) and robustness (SA < 0.001). The evaluation of the models’ responses to simulated sensor faults (offset, drift, precision degradation, stuck-at) revealed characteristic residual patterns for faults with magnitudes > 5 µm. These findings establish the foundation for developing a fault detection and isolation algorithm for continuous monitoring of these sensors’ operational health. For practical implementation, the models require validation across all operational modes, and maximum admissible deformation thresholds must be defined.
1 August 2018 in Journal of Physics: Conference Series
Society dynamics development has led to the origination of new metrology challenges. Among the most actual problems are the issues related to forming efficient measurement models and forecasting long-term variation of multidimensional, mainly, non-physical quantities as well as to automation of checking measurement result trustworthiness, to timeliness and security of measurement result transmission. The necessity to perform investigations and the development of international standards in the above-mentioned fields has been pointed.
1 November 2019 in Journal of Physics: Conference Series
Civilization development requires a multifold increase in the volume of measuring information. Such an increase, to a significant extent, is caused by the necessity to solve qualitatively new measuring tasks. To meet this need is possible by the transition to new measuring technologies. The experience of the D.I. Mendeleyev Institute for Metrology in developing actual technologies, in particular, metrological self-check and virtual tests, proves their efficiency and discloses realization features.
1 December 2020 in Journal of Physics: Conference Series
At the beginning of the 21st century, the multidimensional problems of studying human and society have gone beyond separate sciences. As a result, the need for measuring properties (with providing measurement result traceability), which were considered immeasurable before, has increased. By performing cross-disciplinary and interdisciplinary investigations, to meet this requirement has become possible. In recent years, such investigations have received increased attention at the IMEKO congresses and symposia as well as other international congresses and conferences devoted to measurement science. Interaction in a creative team that consists of professionals in various scientific fields, development of common databases, work in the Internet on joint documents, etc. result in new problems. Organization difficulties concerning such investigations, capacities for overcoming them as well as the efficiency and features of collaborative work in a creative team, have been shown using the example of the experience obtained at the D.I. Mendeleyev Institute for Metrology.