A paradigm shift towards the utilization of carbon-neutral and low emission fuels is necessary in the internal combustion engine industry to fulfil the carbon emission goals and future legislation requirements in many countries. Hydrogen as an energy carrier and main fuel is a promising option due to its carbon-free content, wide flammability limits and fast flame speeds. For spark-ignited internal combustion engines, utilizing hydrogen direct injection has been proven to achieve high engine power output and efficiency with low emissions. This review provides an overview of the current development and understanding of hydrogen use in internal combustion engines that are usually spark ignited, under various engine operation modes and strategies. This paper then proceeds to outline the gaps in current knowledge, along with better potential strategies and technologies that could be adopted for hydrogen direct injection in the context of compression-ignition engine applications—topics that have not yet been extensively explored to date with hydrogen but have shown advantages with compressed natural gas.

The effects of charge dilution on low-temperature diesel combustion and emissions were investigated in a small-bore single-cylinder diesel engine over a wide range of injection timing. The fresh air was diluted with additional N2 and CO2, simulating 0 to 65% exhaust gas recirculation in an engine. Diluting the intake charge lowers the flame temperature T due to the reactant being replaced by inert gases with increased heat capacity. In addition, charge dilution is anticipated to influence the local charge equivalence ratio ϕ prior to ignition due to the lower O2 concentration and longer ignition delay periods. By influencing both ϕ and T, charge dilution impacts the path representing the progress of the combustion process in the ϕ-T plane, and offers the potential of avoiding both soot and NOx formation. In-cylinder pressure measurements, exhaust-gas emissions, and imaging of combustion luminosity were performed to clarify the path of the combustion process and the effects of charge dilution and injection timing on combustion and fuel conversion efficiency. Based on the findings, a postulated combustion process in the ϕ-T plane is presented for different dilution levels and injection timings. Although the ignition delay increased with high dilution and early injection, the heat release analysis indicated that a large portion of the combustion and emissions formation processes was still dominated by the mixing-controlled phase rather than the premixed phase. Because of the incomplete premixing, and the need to mix a greater volume of charge with unburned or partially-burned fuel to complete combustion, the diluted mixtures increased CO emissions. Injecting the fuel at earlier timings to extend the ignition delay helped alleviate this problem, but did not eliminate it. Fuel conversion efficiencies calculated for each dilution level and start of injection provide guidance as to the appropriate combustion phasing and practical levels of charge dilution for this low-temperature diesel combustion regime.

Shadowgraph/schlieren imaging techniques have often been used for flow visualization of reacting and non-reacting systems. In this paper we show that high-speed shadowgraph visualization in a high-pressure chamber can also be used to identify cool-flame and high-temperature combustion regions of diesel sprays, thereby providing insight into the time sequence of diesel ignition and combustion. When coupled to simultaneous high-speed Mie-scatter imaging, chemiluminescence imaging, pressure measurement, and spatially-integrated jet luminosity measurements by photodiode, the shadowgraph visualization provides further information about spray penetration after vaporization, spatial location of ignition and high-temperature combustion, and inactive combustion regions where problematic unburned hydrocarbons exist. Examples of the joint application of high-speed diagnostics include transient non-reacting and reacting injections, as well as multiple injections. Shadowgraph and schlieren image processing steps required to account for variations of refractive index within the high-temperature combustion vessel gases are also shown.