Yu Hong

Dr. Yu Hong

orcid

Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
7 August 2023 in Journal of Analytical and Applied Pyrolysis
Verified
Journal Article
Closed access
YHYu Hong
Yu Hong
JGJun Guan
Jun Guan
CLChanghai Liang
Changhai Liang
DHDemin He
Demin He
YFYuqiang Fan
Yuqiang Fan
QZQiumin Zhang
Qiumin Zhang

28 January 2023 in Journal of Analytical and Applied Pyrolysis
Verified
Journal Article
Closed access
YHYu Hong
Yu Hong
JGJun Guan
Jun Guan
CLChanghai Liang
Changhai Liang
FNFan Nie
Fan Nie
DHDemin He
Demin He
QZQiumin Zhang
Qiumin Zhang

4 May 2026 in Combustion and Flame
Verified
Journal Article
Closed access
XGXiaoye Geng
Xiaoye Geng
WGWei Gao
Wei Gao
TZTianjiao Zhang
Tianjiao Zhang
KZKai Zhang
Kai Zhang
YHYu Hong
Yu Hong
Haipeng JiangHaipeng Jiang
Haipeng Jiang

13 February 2026 in Micromachines
Verified
Journal Article
Open access
PDF file
XWXueqi Wang
Xueqi Wang
YHYu Hong
Yu Hong
GWGuohui Wu
Guohui Wu
YHYujie Hou
Yujie Hou
SZShengnan Zhao
Shengnan Zhao
JYJun Yu
Jun Yu
Gas sensors based on metal oxide semiconductors (MOS) have attracted significant attention in monitoring of methane emission and leakage monitoring due to their high sensitivity, fast response time, simple structure and low cost. However, the high power consumption caused by long-term high-temperature operation of MOS sensors restricts their application in mobile and portable devices. In this study, MOF-derived Co3O4 dodecahedrons for low-concentration methane detection at room temperature was prepared using Zeolitic Imidazolate Framework-67 (ZIF-67) as a template and with various calcination temperatures. Among them, the Co3O4-350 calcined at 350 °C exhibited the optimal CH4 sensing performance at room temperature, with a response of Rg/Ra = 1.53 to 2000 ppm CH4. This enhanced gas sensing performance is attributed to the highest Co3+ proportions and the largest specific surface area in Co3O4-350 nanomaterials, which provided more active sites for gas adsorption and reaction. To address the challenge of slow response speed and irrecoverability during CH4 detection at room temperature, the Co3O4 nanomaterials were printed onto a micro-heater plate (MHP) to form a MEMS gas sensor. By introducing a pulse heating mode to the MEMS sensor, the response and recovery time were significantly reduced to 26 s and 21 s, respectively. This enhancement improves both the efficiency and reliability of the MEMS gas sensor for early-stage detection of CH4 leaks in various industrial applications.

7 March 2026 in SSRN Electronic Journal
Verified
Preprint
Open access
JQJing Qi
Jing Qi
YHYu Hong
Yu Hong
TZTianjiao Zhang
Tianjiao Zhang
YLYanchao Li
Yanchao Li
The influence of length-to-diameter ratio on hydrogen-doped methane explosion in confined pipelines was investigated through a combined experimental and theoretical approach. Experimental results indicate that the number of flame acceleration events increases with the increase of the length-to-diameter ratio. Accelerated propagation is more likely to occur under larger length-to-diameter ratios, higher hydrogen doping ratios, and equivalence ratios closer to stoichiometric. At low hydrogen doping ratios, the explosion overpressure peak is highest at position P1, while the explosion overpressures at other positions are relatively similar. As the hydrogen doping ratio increases, the explosion overpressure peaks at both ends of the pipeline become greater than those in the middle section, accompanied by high-frequency oscillations. The experimental values of explosion overpressure peak decrease with increasing length-to-diameter ratio. In contrast, the theoretical values of explosion overpressure peak are unaffected by the length-to-diameter ratio and consistently exceed the experimental values. This discrepancy is attributed to heat loss during the experiments, which becomes more significant at lower hydrogen doping ratios and larger length-to-diameter ratios. A prediction model of the maximum pressure rise rate was proposed. The experimental values of the maximum pressure rise rate fall between the predicted values for laminar and turbulent conditions, with larger length-to-diameter ratios resulting in behavior closer to the turbulent state.

18 April 2026 in Fuel
Verified
Journal Article
Closed access
JQJing Qi
Jing Qi
YHYu Hong
Yu Hong
TZTianjiao Zhang
Tianjiao Zhang
YLYanchao Li
Yanchao Li