The steel industry contributes to approximately 7%–9% of global anthropogenic CO_2(g) emissions, with traditional blast furnace–basic oxygen furnace (BF–BOF) routes emitting up to 1.8 t_CO2 per ton of steel. In contrast, Electric Arc Furnace (EAF) steelmaking, especially when integrated with hydrogen direct-reduced iron (DRI), can reduce emissions by over 40%, positioning EAFs as a key enabler of low-carbon metallurgy. However, despite its lower direct emissions, the EAF process still depends on fossil carbon sources for slag foaming and FeO reduction, which are essential for arc stability and energy efficiency. Slag foaming plays a critical role in controlling the thermal efficiency of the EAF by shielding the electric arc, reducing radiative heat losses, and stabilizing the arc’s behavior. This review examines the mechanisms of slag foaming, discussed through empirical models that consider the foaming index (Σ) and slag foaming rate as critical parameters, and highlights the influence of physical properties such as slag viscosity, surface tension, and density on gas bubble retention. Also, the work embraces the potential use of alternative carbon sources including biochar, biomass, and waste-derived materials such as plastics and rubber to replace fossil-based reductants and foaming agents in EAF operations. Finally, it discusses the use of new materials with a biological base, such as nanocellulose, to serve as reactive templates for producing nanohybrid materials, containing both oxides, which can contribute to slag basicity (MgO and/or CaO, for example), together with a reactive carbonaceous phase, derived from the organic fiber’s thermal degradation, which could contribute to slag foaming, and could replace part of the fossil fuel charge to be employed in the EAF process. In this context, the development and characterization of renewable carbonaceous materials capable of simultaneously reducing FeO and promoting slag foaming are essential to achieving net-zero steel production and enhancing the sustainability of EAF-based steelmaking.

The objective of this research was to design and construct an artificial light machine that simulates the solar illuminations of the coast, highlands, and jungle of Peru, evaluating its impact on solar panels. The methodology included the construction of the machine at the University of Lima and tests with a module composed of an artificial light source, a solar panel, a measurement module, and an ammeter clamp. Tests were conducted varying the illumination to simulate the conditions of the different regions of Peru. The results obtained were 4,8; 7,2 and 4,0 kWh/m² for the simulations of the coast, highlands, and jungle, respectively. The research concluded that it is feasible to develop a solar lighting source that improves the efficiency of solar panels and allows working under stationary conditions. However, it is necessary to increase the number of tests and improve their precision for a more objective evaluation of their practical utility.