The international journal of Aerosol and Air Quality Research (AAQR) covers all aspects of aerosol science and technology, atmospheric science and air quality related issues.
The positive matrix factorization (PMF) model is widely used for source apportionment of volatile organic compounds (VOCs). The question about how to select the proper number of factors, however, is rarely studied. In this study, an integrated method to determine the most appropriate number of sources was developed and its application was demonstrated by case study in Wuhan. The concentrations of 103 ambient volatile organic compounds (VOCs) were measured intensively using online gas chromatography/mass spectrometry (GC/MS) during spring 2014 in an urban residential area of Wuhan, China. During the measurement period, the average temperature was approximately 25 °C with very little domestic heating and cooling. The concentrations of the most abundant VOCs (ethane, ethylene, propane, acetylene, n-butane, benzene, and toluene) in Wuhan were comparable to other studies in urban areas in China and other countries. The newly developed integrated method to determine the most appropriate number of sources is in combination of a fixed minimum threshold value for the correlation coefficient, the average weighted correlation coefficient of each species, and the normalized minimum error. Seven sources were identified by using the integrated method, and they were vehicular emissions (45.4%), industrial emissions (22.5%), combustion of coal (14.7%), liquefied petroleum gas (LPG) (9.7%), industrial solvents (4.4%), and pesticides (3.3%) and refrigerants. The orientations of emission sources have been characterized taking into account the frequency of wind directions and contributions of sources in each wind direction for the measurement period. It has been concluded that the vehicle exhaust contribution is greater than 40% distributed in all directions, whereas industrial emissions are mainly attributed to the west southwest and south southwest.
5 September 2018 in Environmental Chemistry Letters
Curcumin is a natural active constituent with a great variety of beneficial biological and pharmacological activities, is a practically water‐insoluble component. The scope of the present work was to prepare a solid dispersion (SD) formulation to enhance the dissolution rate of curcumin. The SD was prepared using curcumin and β ‐cyclodextrin (CD)/HA via a classical ethanol‐based solvent evaporation method. The as‐prepared β ‐CD/HA and SDs were selectively characterised by various analytical techniques including X‐ray diffraction, transmission electron microscopy, scanning electron microscopy, specific surface area/pore size analysis, Fourier transform infrared spectroscopy, and high‐performance liquid chromatography. According to the dissolution tests, it was confirmed that β ‐CD/HA–curcumin SD can significantly enhance the dissolution of curcumin. In addition, an increasing trend was seen between the β ‐CD weight ratio and the dissolution rate of curcumin, and β ‐CD/HA–curcumin (9:1) SD was shown to be the best formulation among all tested samples with over 90% curcumin dissolved in 180 min. Besides, β ‐CD/HA–curcumin (9:1) SD exhibited pH and medium‐dependent curcumin release behaviours. The antioxidant activity of released curcumin showed no difference to original curcumin. These results clearly demonstrated β ‐CD/HA can be a promising SD carrier to improve the dissolution of curcumin.