Low-viscosity slickwater fracturing fluids are a crucial technology for the commercial development of shallow shale gas. However, in deep shale gas formations with high pressure, a higher sand concentration is required to support fractures. Linear gel fracturing fluids and crosslinked gel fracturing fluids have a strong sand-carrying capacity, but the drag reduction effect is poor, and it needs to be pre-prepared to decrease the fracturing cost. Slick water fracturing fluids have a strong drag reduction effect and low cost, but their sand-carrying capacity is poor and the fracturing fluid sand ratio is low. The research and development of viscous slick water fracturing fluids solves this problem. It can be switched on-line between a low-viscosity slick water fracturing fluid and high-viscosity weak gel fracturing fluid, which significantly reduces the cost of single-well fracturing. A polyacrylamide drag reducer is the core additive of slick water fracturing fluids. By adjusting its concentration, the control of the on-line viscosity of fracturing fluid can be realized, that is, ‘low viscosity for drag reduction, high viscosity for sand-carrying’. Therefore, this article introduces the research and application status of a linear gel fracturing fluid, crosslinked gel fracturing fluid, and slick water fracturing fluid for deep shale gas reservoirs, and focuses on the research status of a viscous slick water fracturing fluid and viscosity-controllable polyacrylamide drag reducer, with the aim of providing valuable insights for the research on water-based fracturing fluids in the stimulation of deep shale gas reservoirs.

Slickwater fracturing has become an adopted technology for enhancing hydrocarbon recovery from unconventional, low-permeability reservoirs such as shale and tight formations, owing to its ability to generate complex fracture networks at a low cost. Polyacrylamide and polyacrylamide-based gels serve as key additives in these fluids, primarily functioning as drag reducers and thickeners. However, downhole environments of high-temperature (>120 °C) and high-salinity (>1 × 10⁴ mg/L) reservoirs pose challenges, leading to thermal degradation and chain collapse of conventional polyacrylamide, which results in performance loss. To address these limitations, synthesis methods including aqueous solution polymerization, inverse emulsion polymerization, and aqueous dispersion polymerization have been developed. This review provides an overview of molecular design methods aimed at enhancing performance stability of polyacrylamide-based polymers under extreme conditions. Approaches for improving thermal stability involve synthesis of ultra-high-molecular-weight polyacrylamide, copolymerization with resistant monomers, and incorporation of nanoparticles. Methods for enhancing salt tolerance focus on grafting anionic, cationic, or zwitterionic side chains onto the polymer backbone. The drag reduction mechanisms and gelation methods of these polymers in slickwater fracturing fluids are discussed. Finally, this review outlines research directions for developing next-generation polyacrylamide polymers tailored for extreme reservoir conditions, offering insights for academic research and field applications.