Wenzhe Mao

Prof. Dr. Wenzhe Mao


Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 February 2019 in Review of Scientific Instruments
Verified
Journal Article
Closed access
PDF file
XFX. Feng
X. Feng
ALA. D. Liu
A. D. Liu
CZC. Zhou
C. Zhou
MWM. Y. Wang
M. Y. Wang
JZJ. Zhang
J. Zhang
WLW. D. Liu
W. D. Liu
A 5-channel Doppler backscattering system has been designed and installed in the Experimental Advanced Superconducting Tokamak (EAST). Through an I/Q-type double sideband modulator and a frequency multiplier, an array of finely spaced (Δf = 400 MHz) frequencies that span 1.6 GHz has been created. The center of the array bandwidth is tunable within the range of 75-97.8 GHz, which covers most of the W band (75-110 GHz). The incident angle can be adjusted from −4° to 12°, and the wavenumber range is 4-15 cm−1 with a wavenumber resolution of Δk/k ≤ 0.35. Ray tracing is used to calculate the scattering location and the scattering wavenumber. This article details the hardware design, the ray tracing, and the preliminary experimental results from EAST plasmas.

23 January 2023 in IEEE Transactions on Antennas and Propagation
Verified
Journal Article
Open access
WOWenchong OuYang
Wenchong OuYang
QLQi Liu
Qi Liu
WMWenzhe Mao
Wenzhe Mao
SGShuzhan Gao
Shuzhan Gao
ZWZhengwei Wu
Zhengwei Wu
High density plasma source device is of great significance for ground experiment verification of vehicle reentry communication. APPJ, as a high-density plasma source, has received little attention in ground experiments on vehicle communications. In this paper, terahertz wave propagation characteristics in APPJ are investigated by joint simulation of APPJ discharge and terahertz transport model and related experimental measurements. THz-IF system is used to diagnose the electron density and terahertz transmission characteristics of APPJ for the first time, and the measured results are in good agreement with simulation results of joint simulation model in this paper and measured results of THz-TDS system of other researchers. Sheath thickness and electron density produced by self-designed APPJ are highly matched with the plasma sheath environment of HIFIRE-5b vehicle. Further analysis of the influence of different voltages and needle electrode radius on the terahertz transmission characteristics shows that the absorption effect plays a major role in terahertz wave attenuation in APPJ, and contribution of collision effect almost disappears, which is completely consistent with the phenomenon observed in HIFIRE-5b vehicle. The joint simulation model and THZ-IF method developed in this paper are of great significance for the ground test verification of reentry communication schemes.

22 July 2019 in Nuclear Fusion
Verified
Journal Article
Open access
PDF file
WLWandong Liu
Wandong Liu
WMWenzhe Mao
Wenzhe Mao
TLTao Lan
Tao Lan
GZGe Zhuang
Ge Zhuang
JZJian Zheng
Jian Zheng
WDWeixing Ding
Weixing Ding
The Keda Torus eXperiment (KTX) is still operated in the commissioning phase, and preparation for the operation capability of the KTX phase II upgrade is underway. The diagnostics in the KTX have been greatly developed: (1) the terahertz interferometer has been upgraded to seven chords for electron density profile inversion; (2) a Thomson scattering system with a 5 Joule laser has been installed and commissioning is in progress; (3) a 3D movable probe system has been developed for the electromagnetic turbulence measurement; (4) double-foil soft x-ray imaging diagnostics have been set up and a bench test has been completed; (5) an edge capacitive probe has been installed for the radial electrical field measurement; (6) a multi-channel spectrograph system has been built for detecting impurities of carbon and oxygen. In addition, the design of a new compact torus injection system has been completed for feeding and momentum driving. Pilot research, such as the 3D reversed field pinch physics and electromagnetic turbulence, etc, have been conducted in the discharge status of the KTX. The 3D spectra characters of electromagnetic turbulence are firstly measured using a classical two-point technique by Langmuir probe arrays set on the 3D movable probe system and edge magnetic sensors. The forward scattering is collected by the interferometer system, which shows the potential for turbulence research. The electromagnetic turbulence is tentatively investigated in the KTX. The formation of a quasi-single-helicity state in the KTX regime is also preliminarily explored in simulation.

1 October 2018 in Physics of Plasmas
Verified
Journal Article
Closed access
PDF file
MWM. Y. Wang
M. Y. Wang
CZC. Zhou
C. Zhou
ALA. D. Liu
A. D. Liu
JZJ. Zhang
J. Zhang
ZLZ. Y. Liu
Z. Y. Liu
WLW. D. Liu
W. D. Liu
The magnetic fluctuations of geodesic acoustic modes (GAMs) have been investigated using a Doppler backscattering system and Mirnov probes during ion cyclotron resonance heating and lower hybrid wave heating in the edge plasma in the experimental advanced superconducting tokamak, and the magnetic component of the GAM was observed. The frequency of the GAM has a clear relationship with the edge electron temperature, and the mode numbers of the poloidal component of the magnetic structure of the GAM are approximately m = 2   ( sin   ( 2 θ ) ) and n = 0. A more detailed investigation shows that the maximum values of the amplitude of the poloidal magnetic field fluctuations and poloidal electric field fluctuations are approximately 10 − 6 T and 200 V/m, respectively.

1 June 2020 in Review of Scientific Instruments
Verified
Journal Article
Closed access
PDF file
SZSen Zhang
Sen Zhang
CCChen Chen
Chen Chen
TLTao Lan
Tao Lan
WDWeixing Ding
Weixing Ding
GZGe Zhuang
Ge Zhuang
WLWandong Liu
Wandong Liu
An optical fiber Mach–Zehnder interferometer at a wavelength of 1.55 µm has been developed for measurements of high electron density on compact torus (CT) plasmas with a high time resolution of 0.1 µs and high phase resolution of 6.4 × 10−4 rad. To improve density measurement accuracy, the phase noise of the interferometer has been investigated in detail and optimized. In the bench test, the interferometer was calibrated using a piezoelectric ceramic actuator with known stroke. Initial results on CT plasma show that the optical fiber interferometer provides reliable density measurements at two spatial locations and the bulk velocity of plasma can be determined by the method of time of flight.

1 November 2016 in Review of Scientific Instruments
Verified
Journal Article
Closed access
PDF file
ZLZichao Li
Zichao Li
HLHong Li
Hong Li
CTCui Tu
Cui Tu
JHJintong Hu
Jintong Hu
WYWei You
Wei You
WLWandong Liu
Wandong Liu
In a reversed field pinch device, the conductive shell is placed as close as possible to the plasma so as to balance the plasma during discharge. Plasma instabilities such as the resistive wall mode and certain tearing modes, which restrain the plasma high parameter operation, respond closely with conditions in the wall, in essence the eddy current present. Also, the effect of eddy currents induced by the external coils cannot be ignored when active control is applied to control instabilities. One diagnostic tool, an eddy current probe array, detects the eddy current in the composite shell. Magnetic probes measuring differences between the inner and outer magnetic fields enable estimates of the amplitude and angle of these eddy currents. Along with measurements of currents through the copper bolts connecting the poloidal shield copper shells, we can obtain the eddy currents over the entire shell. Magnetic field and eddy current resolutions approach 2 G and 6 A, respectively. Additionally, the vortex electric field can be obtained by eddy current probes. As the conductivity of the composite shell is high, the eddy current probe array is very sensitive to the electric field and has a resolution of 0.2 mV/cm. In a bench test experiment using a 1/4 vacuum vessel, measurements of the induced eddy currents are compared with simulation results based on a 3D electromagnetic model. The preliminary data of the eddy currents have been detected during discharges in a Keda Torus eXperiment device. The typical value of toroidal and poloidal eddy currents across the magnetic probe coverage rectangular area could reach 3.0 kA and 1.3 kA, respectively.