Wearable sensing solutions have emerged as a promising paradigm for monitoring human musculoskeletal state in an unobtrusive way. To increase the deployability of these systems, considerations related to cost reduction and enhanced form factor and wearability tend to discourage the number of sensors in use. In our previous work, we provided a theoretical solution to the problem of jointly reconstructing the entire muscular-kinematic state of the upper limb, when only a limited amount of optimally retrieved sensory data are available. However, the effective implementation of these methods in a physical, under-sensorized wearable has never been attempted before. In this work, we propose to bridge this gap by presenting an under-sensorized system based on inertial measurement units (IMUs) and surface electromyography (sEMG) electrodes for the reconstruction of the upper limb musculoskeletal state, focusing on the minimization of the sensors’ number. We found that, relying on two IMUs only and eight sEMG sensors, we can conjointly reconstruct all 17 degrees of freedom (five joints, twelve muscles) of the upper limb musculoskeletal state, yielding a median normalized RMS error of on the non-measured joints and on the non-measured muscles.
Following the growing interest in small-scale unmanned aerial vehicles (UAVs), this paper presents a comprehensive conceptual design methodology for a modular ducted-fan aerial vehicle intended for research applications. Although ducted-fan configurations offer significant advantages over conventional multirotor platforms, particularly in urban, indoor, and human-interaction scenarios, the availability of affordable and customizable ducted-fan UAVs platforms suitable for scientific research remains limited. To address this gap, the paper details the complete design of the vehicle, including propeller aerodynamics and duct design, mechanical structure, actuation system, dynamic modeling, and control strategy. All major structural and aerodynamic components are fabricated using low-cost additive manufacturing, enabling rapid prototyping and high modularity. The vehicle’s performance is experimentally assessed through bench tests and indoor flight experiments, demonstrating stable flight and satisfactory attitude control. The presented work shows that a fully functional ducted-fan UAVs can be realized using commercial off-the-shelf electronics and exclusively 3D-printed components, and provides practical guidelines to replicate and adapt the proposed platform for advanced research in UAVs control, navigation, and autonomy.