Nd1−xPbxFeO3 (x = 0.1–0.3) solid solutions were prepared by aliovalent substitution of Pb2+ at the Nd3+ site using the conventional solid-state reaction route. The structural, magnetic and dielectric properties and hopping mechanism of these solid solutions are reported. XRD data shows that all the samples possessed orthorhombic crystal structures. No impurity phase was found, indicating that Pb2+ was well within its solid solubility limit. All samples exhibited magnetic ordering with the Mr value decreasing from 2.42 emu/g for the x = 0.1 sample to 1.79 emu/g for the x = 0.3 sample. The coexistence of the multi-valance state of the Fe ion was explored using XPS analysis. The dielectric constant (ε׳) and dielectric loss (ε״) were found to decrease with increases in the frequency of the applied electric field and to show Cole–Cole relaxation behavior. The temperature-dependent variation of exponent “n” (obtained from the Jonscher’s power law fitting) explains the conduction model that the system follows exactly.
The structural, magnetic, and electronic properties of iron doped barium strontium titanate (Ba0.7Sr0.3FexTi1−xO3 where x = 0, 0.1, 0.2, 0.3; BSTF) solid solutions synthesized via solid state reaction route were investigated. X-ray diffraction patterns of all the samples clearly show phase formation with the absence of impurity peaks. The Rietveld refinement confirmed the coexistence of the tetragonal and cubic phase for samples with Fe content x = 0, 0.1 and pure cubic phase for x > 0.1. The M–H hysteresis curves for samples with composition x = 0.1 and 0.2 exhibit paramagnetic behaviour even at low temperatures and the composition with x = 0.3 shows the nature of weak ferro- and ferri-magnetic orderings at about 2 K. X-ray absorption near edge structure (XANES) spectroscopy reveals the presence of Fe2+ with an increase in the Fe content and also the mixed valence states of Fe ions.
Polycrystalline samples of Pb1-xLax/2Smx/2Ti1-xFexO3 (x = 0.20 and 0.30) have been prepared by solid state reaction route. The electrical properties of synthesized samples have been investigated using complex impedance spectroscopy as a function of frequency (100 Hz–1 MHz) within the temperature range of (448–573 K). The fitting of the Nyquist plots reveals that both grain and grain boundary contribute to relaxation and the grain boundaries are more resistive and capacitive than the grains. Modulus analysis shows that relaxation in both the samples is of non-Debye type and temperature independent. The Jonscher`s power law fit to the ac conductivity data confirms that the conduction in the prepared samples is due to the hopping of charge carriers. Long range conductivity type of relaxation is found in both the samples.
Solid solutions of (x)SmFeO3-(1-x)Ba(Zr0.05Ti0.95)O3: x = 0, 0.21, 0.22 and 0.23 were synthesized by the solid-state reaction route. Le-Bail analysis of the X-ray diffraction data and Raman spectra revealed the presence of the tetragonal phase (P4mm space group 99). The remnant polarization (Pr) was ~4.08 µC/cm2 and 1.04 µC/cm2 for x= 0 and x= 0.21, respectively, while lossy loops were observed for x≥ 0.22. Canting of the antiferromagnetic spins and ferromagnetic exchange mechanism was responsible for the ferromagnetic feature in the samples. An increase in remnant magnetization (Mr) was observed with increases in x. The Nyquist plots revealed the existence of grain and grain boundaries in the overall impedance. Separation of the normalized plots of impedance (Z˝) and modulus (M˝) spectra indicated localized motion of the charge carriers in the sample. The Maxwell–Wagner model fits very well in the low-frequency region ( 105 Hz). The ac conductivity obeyed the Universal Jonscher’s Power law. The variations in the exponent n suggest that the conduction mechanism conforms to the small polaron hopping mechanism.