The use of marble waste as a secondary raw material in production helps to reduce environmental damage. In this study, samples of ceramic wall tiles (WT) (10 % calcite replacement) and samples of polypropylene (PP) composites washing machine drums (43 % calcite replacement) were prepared using marble waste powders (WMP). Measurements of water absorption (%), fracture strength (kg/cm 2 ), firing strength (kg/cm 2 ) and color properties (L, a, b) were performed on the WT samples. In addition, the physical and mechanical properties such as compression, tensile and flexural behavior were investigated on the specimens of polypropylene composites with calcite (PP-C) and polypropylene composites with WMP (PP-WM) composites. The use of WMP in the production of WTs reduces the water absorption capacity due to its hydrophobicity. However, no significant changes were observed in the fracture strength values for WMP-WT samples and STD-WT samples. When waste marble powder was used in PP drum composites, an increase in MFi of approximately 23 % was observed, although the mechanical properties of the composites decreased slightly. Regarding the use of WMP as a secondary raw material, the predicted results were in agreement with the experimental observations.
Microplastic Pollution in Ship-Sourced Wastewater: Assessment of Pollution Load Risk for Ballast and Bilge Water - Journal of Naval Architecture and Marine Technology
Corrosion is a critical factor in maintaining the integrity of marine facilities such as ship structures, offshore platforms, and other infrastructure, as it leads to surface deformation, including cracking and pitting. This research presents a comparative study of the effects of marine and other aquatic environments on AISI 304, AISI 304L, AISI 316L, and AISI 420 stainless steel (SS) metals. Tafel polarization tests were conducted to evaluate the breakdown potential of the passive film for these four SS types under different aquatic conditions. Corrosion resistance increased in the order AISI 420 < AISI 304 < AISI 304L < AISI 316L. The best-performing materials in all media were AISI 316L and AISI 304L, which exhibited the widest passive range, the lowest corrosion current density, and the highest polarization resistance. The results reveal that the breakdown potential is lower at higher salinity, indicating that increasing the ionic species and salt concentrations in seawater also increases corrosion attack on the metal surface. Based on the study’s outcomes, corrosion rates after 30 days ranged from 0.050 mm y −1 to 0.0245 mm y −1 . The I corr value of AISI 304L steel decreased significantly from 72.43 to 6.11 μA cm −2 after 30 days of exposure, While AISI 420 SS and AISI 304 were the most affected by corrosion in seawater.
23 July 2026 in Journal of Water Chemistry and Technology
In the present study, the effects of the combination of electrooxidation (EOx) and ozone (O3) processes on chemical oxygen demand (COD) removal and associa