The number of mobile users on onboard vehicles is increasing continuously. Vehicular users suffer from vehicle penetration loss, fast variation of channel conditions, and signal strengths. These challenges are made even worse by a growing need for high data rates and high quality of service requirements in vehicular scenarios, which cause frequent handovers, call drops, and complete outages. The achievable rate supports adapting techniques for communication to dynamically changing conditions, ensuring reliable and efficient transmission of information despite variations. Moving relay (MR) has been proven to be one of the most promising techniques for handling such scenarios over Rayleigh fading channels. However, the performance of MR for non-vehicular users needs to be analyzed over Rician fading channel in terms of achievable rate. This paper proposes a cooperative non-orthogonal multiple access (NOMA) based system over Rician fading for non-vehicular users with half duplex decode and forward protocol-based MRs in downlink communication.We derive the achievable sum rate of the proposed system for non-vehicular users and analyze its performance in terms of power allocation coefficient, transmit signal-to- noise ratio (SNR), and Rician factor. Also, a comparison of the proposed system with a conventional orthogonal multiple access (OMA) system is provided. The simulation results show that the proposed cooperative NOMA system achieves 11.96 % higher achievable sum rate at 5 dB SNR and 14.88% higher achievable sum rate at 25 dB SNR compared to conventional OMA system.The analytical results are verified through Monte Carlo simulations. The proposed system may be useful for designing high-speed vehicular scenarios in 5G and beyond communication.
The coronavirus disease (COVID-19) outbreak is a serious problem for the entire planet. The respiratory system is attacked by the coronavirus, as is the immune system. According to a WHO report, contact with an infected individual and droplets produced by coughing or sneezing are the main ways that the coronavirus spreads. Anyone who breathes in these airborne respiratory droplets contributes to the transmission of illness. On the other side, these droplets could also spread disease to contact surfaces like hands. Healthcare professionals are constantly at risk for infection because they come into touch with infected people due to their direct involvement in the diagnosis, treatment, and care of COVID-19 patients. As a result, contactless monitoring and management of such infectious diseases becomes a laborious task, and the safety of these individuals becomes a top priority. In the current project, we used a Node MCU board and an MLX90614 infrared temperature sensor to build an infrared thermometer. We were able to display the temperature reading on an OLED display. Contactless temperature sensing is a technique used by the MLX90614 sensor to obtain temperature data without making direct physical contact with a particular surface. To direct the sensor toward a specific item, we made use of a laser diode. The MLX90614 has an extremely fast refresh rate and sensitivity, allowing it to provide a reading in only a few hundredths of a second. Within the last several years, COVID-19 has raised demand for this sensor. By utilizing Node MCU and IoT technologies, this infrared thermometer may transfer data remotely to the physicians or remote locations. From anywhere in the world, the system is capable of sending data to the Blynk server. <!----> <!----> <!----> <!---->