Under weak grid conditions, the coupling between the grid-connected converter and the grid impedance tends to bring in harmonic instability in the permanent-magnet synchronous generators (PMSGs)-based wind farm system. Although the symmetrical phase-locked loop (SPLL) can decouple the converter from the grid, it exerts an impact on the system stability. To address this issue, this paper proposes a partial impedance decoupling control method based on the SPLL. Based on a small-signal impedance model, the grid-GSC impedance decoupling mechanism of the SPLL and its adverse impact on system stability are analytically revealed. Furthermore, a partial impedance decoupling method is realized that incorporates adjustment coefficients and symmetric compensation to achieve a trade-off between damping enhancement and coupling mitigation, thus expanding the stable operating range of the PMSG-based wind farm system. Both simulation and experimental results demonstrate that the proposed strategy significantly improves system stability and maintains stable operation under grid conditions with a 10% reduction in short-circuit ratio (SCR).
Rapid load growth and increasing operational uncertainty pose significant challenges to conventional distribution network planning. To address these challenges, this paper proposes a robust dynamic co-planning framework for distribution feeders and virtual distribution feeders (VDFs). Firstly, a dynamic co-planning model is developed to jointly optimize feeder reinforcement and battery energy storage system (BESS)-based non-wire alternatives over a multi-year horizon. Then, a robustness index (RI) is proposed to quantitatively evaluate the robustness of planning solutions under operational uncertainties without relying on assumed probability distributions. Four objectives are optimized simultaneously: (1) net present value cost (NPV), (2) cumulative overload quantity (COQ), (3) incremental capacity idle rate (ICIR), and (4) robustness index (RI). In addition, feeder emergency rating and battery degradation are incorporated to capture feeder-side thermal flexibility and storage aging characteristics in the planning process. Finally, the proposed method is tested on a modified IEEE 33-bus system. The results show that the proposed framework achieves a superior trade-off between cost, utilization, and robustness than conventional approaches, while reducing unnecessary BESS deployment and improving the physical consistency of the planning results.
HVDC technologies based on fully controlled devices offer numerous technical advantages, such as flexible active and reactive power control and black-start capability, making them highly promising for large-scale renewable energy integration and long-distance power transmission. However, their widespread adoption is constrained by high costs and significant power losses. Unlike existing hybrid HVDC schemes predominantly based on LCC-MMC structures, this paper proposes a novel hybrid current source converter-based HVDC (HCSC-HVDC) topology composed of IGCTs and thyristors, which enables power decoupling and achieves an approximate 70.5% reduction in high-voltage capacitor requirements, fundamentally improving system economy and structural efficiency. Firstly, the topological structure of the HCSC is introduced and a mathematical model is established. Then, the power operating range of the hybrid converter is quantitatively analyzed, and an optimization method for AC filter parameters is derived, based on which a power decoupling control strategy and a reactive power coordination control (RPCC) strategy are proposed. Finally, PSCAD electromagnetic transient simulations verify the effectiveness and feasibility of the proposed topology and control methods.