Supercooled large droplet (SLD), which can cause abnormal icing, is a well-known issue in aerospace engineering. Although efforts have been exerted to understand large droplet impact dynamics and the supercooled feature in the film/substrate interface, respectively, the thermodynamic effect during the SLD impact process has not received sufficient attention. This work conducts experimental studies to determine the effects of drop size on the thermodynamics for supercooled large droplet impingement. Through phenomenological reproduction, the rapid-freezing characteristics are observed in diameters of 400, 800, and 1300 μm. The experimental analysis provides information on the maximum spreading rate and the shrinkage rate of the drop, the supercooled diffusive rate, and the freezing time. A physical explanation of this unsteady heat transfer process is proposed theoretically, which indicates that the drop size is a critical factor influencing the supercooled heat exchange and effective heat transfer duration between the film/substrate interface. On the basis of the present experimental data and theoretical analysis, an impinging heating model is developed and applied to typical SLD cases. The model behaves as anticipated, which underlines the wide applicability to SLD icing problems in related fields.
25 June 2023 in International Journal of Hydrogen Energy
In this article, the distributed optimization problem is studied for a class of fractional-order nonlinear uncertain multi-agent systems (MASs) with unmeasured states. Each agent is represented through a system with unknown nonlinearities, unmeasurable states and a local objective function described by a quadratic polynomial function. A penalty function is constructed by a sum of local objective functions and integrating consensus conditions of the MASs. Radial basis function Neural-networks (RBFNNs) and Neural networks (NN) state observer are applied to approximate the unknown nonlinear dynamics and estimate unmeasured states, respectively. By combining the NN state observer and the penalty function, and the stability theory of the Lyapunov function, the distributed observer-based adaptive optimized backstepping dynamic surface control protocol is proposed to ensure the outputs of all agents asymptotically reach consensus to the optimal solution of the global objective function. Simulations demonstrate the effectiveness of the proposed control scheme.
Given the importance of understanding new FAR25, Appendix O certification, supercooled large droplet icing characteristics and its damages should be specified because of its serious hazard to in-flight safety and aircraft engineering. This study compares the icing feature and aerodynamic degradation of high-lift devices under different diameter conditions using a verified numerical method SJTUICE (a ice accretion simulating code by Shanghai Jiao Tong Univeristy). With two different flow and freezing time-steps Tf and Ts, the accuracies on fluid dynamic and icing predictions over a long period of time can be both controlled within an acceptable range. The comparisons between supercooled large droplet and non-supercooled large droplet conditions reflect that larger diameters induce more intense icing characteristics on the suction-side of each airfoil, in which the leading edge of flap is the most sensitive one to drop size. The second-accelerated flow near the gap is adverse to smaller droplet collection but benefit for impact thermodynamic enhancement of those larger collected droplets. The ice-caused gap narrowing makes flow separation earlier, which finally leads to the degradation of global high-lift performance worsen. Lift coefficient comparison also indicates the performance of high-lift devices decays more quickly under supercooled large droplet conditions. Results of this paper highlight the supercooled large droplet icing effects with respect to smaller diameter conditions.