ESAFORM is an association with the mission to stimulate applied and fundamental research in the field of material forming. Its annual conference, the International ESAFORM Conference on Material Forming, is used to achieve one of the main goals of ESAFORM: to spread scientific and technological information related to material forming within academic and industry. The next conference will be held online on 14-16 April 2021.

Precise electrochemical machining (PECM) is being used increasingly to produce turbine blades (high-pressure compressors) from difficult-to-machine materials such as Inconel. However, the challenges associated with PECM are particularly pronounced for filigree workpieces characterized by high aspect ratios and thin-walled geometries. The need for high-pressure flushing within the working gap to renew the electrolyte poses a dilemma because it induces unwanted deflection in these thin-walled structures. This problem is intensified by the mechanical oscillation of the tool applied to promote flushing efficiency. The superposition of mechanical tool oscillation and turbulent flushing, which exacerbate fluid–structure interaction, has been identified as the essential cause of workpiece deflection. The aim of this paper is to present an experimental setup coupled with numerical methods to better investigate the phenomenon of workpiece deflection during PECM. In the first part of this work, a novel tool system for investigating the phenomenon of workpiece deflection in PECM is presented. The tool system combines typical PECM tool–workpiece arrangements for double-sided machining and a unique electrolytic mask that provides optical access to the working gap, allowing in situ measurements. After validating the tool system by experimental tests, the workpiece deflection is investigated using high-speed imaging. In a next step, analytical studies of the flushing conditions during machining operations are carried out. These investigations are followed by a structural investigation of the workpiece to improve the understanding of the deflection behavior of the workpiece. In addition, the effect on the blade tip caused by the continuously decreasing moment of inertia of the blade due to their thinning during machining is analyzed.

Grinding wheel conditioning is critical for maintaining cutting efficiency and surface quality, yet conventional mechanical dressers struggle with metal-bonded superabrasive wheels. In this study, wire electrical discharge machining (WEDM) dressing was evaluated on metal-bond diamond wheels of two grit sizes (D54 and D91) and compared to standard mechanical dressing. Dressing was performed on a WEDM machine using varied discharge currents, open-circuit voltages, and duty factors; subsequently, each wheel ground twelve grooves in tungsten carbide under identical parameters. Performance was assessed via maximum spindle power, tangential and normal forces, surface roughness (Ra), radial wheel wear, and edge radius. WEDM-dressed wheels exhibited up to 56% lower peak spindle power and 40–50% lower forces than mechanically dressed wheels. Compared to mechanically dressed wheels, WEDM-conditioned wheels exhibited markedly lower radial wear and maintained substantially sharper, more stable edge radii throughout the grinding cycles. Surface roughness converged after an initial break-in, matching mechanical methods. By selectively eroding the bond without damaging grains, WEDM dressing extends dressing intervals by approximately fivefold and reduces maintenance.