Disodium Cromoglycate (DSCG), a lyotropic liquid crystal in water, is shown to be an amplifier of chirality when doped with small chiral molecules. Here, we study the behaviour of the DSCG nematic phase in the presence of three aminoacids with different degrees of protonation: L-Alanine, L-Arginine·HCl and L-Arginine. The results demonstrate that the sign of the helicity of the doped nematic phase (i.e., a cholesteric phase) depends on the sign of the Helical Twisting Power of the dopant.
The X-ray crystal structure of the gelator 1,3:2,4-dibenzylidene-D-sorbitol (DBS) is reported here. DBS is an important gelating molecule known for nearly 130 years, that has eluded crystallization until now. The crystal obtained presents an axial stacking of DBS molecules stabilized by both Van der Waals interactions and intermolecular hydrogen bonds of the side chain hydroxyl groups with either neighboring DBS or water molecules. The crystal structure shows definitive evidence for the frequently assumed “butterfly” type aggregation mode and experimentally proves the equatorial placement of the phenyl rings. The conformation of DBS has been analyzed in the crystal structure and compared with that determined in solution through NMR spectroscopy.
To address the limitations of conventional anaerobic digestion (AD), this study explored the integration of microbial electrolysis cells (MECs) with AD to improve biogas production and process stability. While AD is a proven technology for renewable energy recovery from waste, it can suffer from volatile fatty acid accumulation and reduced efficiency. The hybrid MEC–AD system leverages electro-methanogenesis to enhance methane yields and overall system performance. This research evaluated the effects of different electrode materials (graphite plate vs. graphite felt) and applied voltages (0.5 V and 0.7 V) on biogas output, methane content, and operational stability. Results showed that MEC–AD systems significantly outperformed conventional AD, with the highest biogas production reaching 239 ± 3 mL/gVS·d—an increase of up to 162% using graphite felt electrodes at 0.5 V. Internal resistance was also markedly lower with graphite felt (19 Ω/m2) compared to graphite plates (1120 Ω/m2). Furthermore, the pH of the MEC–AD system with graphite felt electrodes was maintained within the optimal range (6.8–7.0), avoiding the acidification seen in control systems. These findings underscore the promise of MEC–AD systems for advancing circular bio-economy initiatives and carbon neutrality. Further work is needed to refine electrode materials and reactor design for improved scalability and efficiency.
The rapid growth of electronic waste (e-waste) has made this stream both an environmental challenge and a valuable secondary source of critical raw materials. Global e-waste generation reached approximately 62 Mt in 2022, while printed circuit boards may contain around 15–30 wt.% Cu, illustrating the considerable resource potential of this waste stream. Recovering these metals is essential to reduce dependence on primary mining and support the transition towards a circular economy. Although pyrometallurgical and hydrometallurgical processes remain the basis of industrial e-waste recycling, they are often constrained by limited selectivity, high energy and reagent consumption, and the need for extensive downstream purification. This review examines the contribution of electrochemical technologies to metal recovery from e-waste. It first outlines the electrochemical principles involved in metal extraction and separation, and then reviews established and emerging technologies for metal extraction, separation, purification, and recovery. Particular attention is given to their integration within hydrometallurgical flowsheets and to differences in technological maturity, selectivity, efficiency, and scalability. For example, industrial copper electrowinning typically requires approximately 1.8–2.5 kWh kg−1 Cu, providing a useful reference benchmark for evaluating secondary-feed applications. Overall, electrochemical technologies offer significant potential to reduce reagent consumption and improve metal selectivity, although their industrial implementation remains strongly dependent on feed composition, process integration, and robust operation under realistic conditions.