An educational software which can aid students in stress analysis of idealized thin-walled open sections has been developed. The software enables students to select different cross-sections which may be subjected to bending, shear or torsional loads and evaluate the stresses on it. Results obtained through this software have been validated. The software has been developed using MATLAB with graphical user interface (GUI). The software is expected to be a useful tool for effective teaching learning process of courses on thin-walled structures and aircraft structures.
Turbulent flow over a 3D backward-facing step at a step-height Reynolds number, Reh, of 5100 is simulated in OpenFOAM using Large Eddy Simulation (LES) to investigate how the definition of the grid-filter width, Δ, influences the computed solutions. As part of this study, two different Δ definitions are tested: and Δ = max(Δx, Δy, Δz). The LES results show good agreement when compared with DNS and experimental data. The simulation results are used to further evaluate the effect of grid non-uniformity on the computation of the subgrid-scale eddy viscosity, νSGS.
9 December 2018 in International Journal of Engineering & Technology
Aerospace structures are typically semi-monocoque structures that are made up of thin-walled closed section reinforced with stiffeners. Stress analysis of such closed thin-walled structures which are statically indeterminate is tedious and time consuming. An educational software which can aid students in carrying out stress analysis of such idealized thin-walled closed sections has been developed. The software enables students to select different types of wing torsion box sections with stiffeners, which may be subjected to bending, shear or torsional loads and evaluate the resulting stresses on it. The software allows the student to idealize a selected twin spar unsymmetrical wing section with multiple booms under multiple loads. Results from this software have been validated against the results in the literature. The software has been developed using MATLAB with graphical user interface (GUI) which is very user friendly.
A dedicated experimental rig is presented for a half-journal bearing operating under highly loaded, well-controlled hydrodynamic lubrication conditions relevant to turbomachinery. The apparatus combines pressure measurements in the film, distributed temperature measurements in the shaft and bush, and ultrasonic film-thickness measurements that map the circumferential film-thickness profile across the lubrication region. Experiments are reported for normal loads of 5–20 kN and shaft speeds of 1000–4000 rpm with controlled oil supply conditions. The measured pressure and temperature trends are consistent with established hydrodynamic lubrication behaviour. The film thickness measurements confirm full-film operation across the tested operating envelope, while indicating increased uncertainty in regions affected by cavitation. A correlation for the temperature rise due to viscous heating is proposed as a compact representation of the data. The rig design and accompanying measurements provide a benchmark-quality data set intended for validation and development of thermal elasto-hydrodynamic lubrication (TEHL)/computational fluid dynamics (CFD) models under high load and speed conditions.