The purpose of this analysis is to evaluate the structural integrity of the jet pump assembly of a BWR during the performance of its operational and safety functions. The natural frequencies and vibration modes of the jet pump assembly immersed in water were determined. It was observed that the fourth mode shape was torsional, and its associated resonance frequency was 41.82 Hz. Also, the vibration induced by the flow in the leakage of the slip joint was analyzed with an axisymmetric model. The gap of the slip joint was varied from 0.2 mm until 0.65bmm. A gap between 0.6 and 0.64, would cause flow-induced vibration because this excitation frequency matches with the fourth natural frequency of the jet pump assembly. The above was carried out using computational fluid dynamics, as well as the finite element method, with ANSYS Structural and ANSYS Fluent codes.

Flow-induced vibrations occur in some of the internal components of a nuclear reactor. When specific conditions are present, these vibrations may result in excessive deformations or fatigue that can generate mechanical damage. Several boiling water reactor (BWR) of nuclear power plants (NPP) have experienced failures in the jet pump assembly due to flow-induced vibration (FIV) which could be caused by acoustic pulsations derived from recirculation pumps, vibration induced by turbulence and vibration induced by leakage at the slip joint. The purpose of this paper is to establish a viable numerical methodology to evaluate the fluid-structural interaction at the slip joint of a jet pump. In this analysis, the fluid-structural interaction was evaluated with the finite element method and finite volume method with ANSYS^® code in the case of two steel plates with a divergent gap. Results show that a critical velocity could cause fluidelastic instability, if only one flow in a two-way fluid-structural interaction was considered. This is one of the phenomena that could take place at the slip joint of a jet pump assembly.