The photovoltaic module (PV) consists of many photovoltaic cells made of silicon that lose their properties with an increased temperature. Increasing photovoltaic cell temperature represents an intrinsic problem that causes a drop in the open-circuit voltage of the PV module, thus affecting its performance. The present work investigates using evaporating cooling as a passive cooling technique to absorb the generated heat from the PV module and lower its temperature by cotton wicks immersed in the water (CWIWs) attached to the backside photovoltaic module. The CWIWs decrease air dry temperature and increase humidity and then produce cool air to help cool PV modules. The results showed dropped PV module temperature by about 22% attributed to providing appropriate cooling produced by the moist condition of the cotton bristles immersed by water exposed to the wind. The output power generation and efficiency have increment by 16.3 W and 53%, respectively. The electrical exergy was equivalent to output power under the evaporating cooling, while entropy generation dropped about 14% with increased the PV module temperature.
Overcoming the issue of photovoltaic (PV) module productivity at high temperatures is one of the most critical obstacles facing its use. PV cells are made of silicon, which loses its properties at high temperatures, degrading the PV module work. The present research compares cotton wicks integrated with rectangular aluminium fins (CWIRAFs) submerged in water as passive cooling with an absorbing plate and copper pipes attached at the PV module backside as active cooling. Compared with the PV module without cooling, CWIRAFs have better performance with the PV module than active cooling owing to evaporative cooling and increased heat dissipation area represented by wet cotton bristles integrated. The PV module is exposed to significant performance degradation without cooling in hot climate conditions. As a result, using CWIRAFs with the PV module had reduced the temperature by 31.4%, increased the power by up to 66.6%, and increased the electrical efficiency from 3.12 to 8.6%. Active cooling methods have reduced the PV temperature by 20.8%, increased the power by 56.7%, and enhanced electrical efficiency by 7.9%. Removing excess heat from the backside of the PV module via circulating water has improved the thermal efficiency and overall efficiency of the PVT system by about 26.3 and 34.2%, respectively.
The energy and exergy efficiency of a photovoltaic thermal (PV/T) system at various volume fractions is investigated with mono TiO2 nanofluid and new hybrid TiO2–Fe2O3 nanofluid. Serpentine tubes soldered on an absorbing plate attached to the rear of the PV module have been proposed to evaluate the effect of nanofluids on the PV/T temperature reduction, energy produced, and exergy losses. The study compared energy and exergy with previous studies and delivered an economic analysis to confirm the feasibility of applying nanofluids. The results indicated that using TiO2–Fe2O3 nanofluid reduced the PV cell's temperature by 42.19% compared to water, TiO2 nanofluid, which increased the electrical power by 74.5% and 46.22% when cooling by mono and hybrid nanofluid at 0.3 vol%. The PV/T system's maximum thermal and electrical efficiency recorded with mono and hybrid nanofluids was 34.6%, 8.44%, 47.2%, and 12.62%, respectively. Dispersion of hybrid nanocomposite in DI water has enhanced the Nu number and HTC by 42.72% and 23% higher than mono nanofluid, which improved the exergy efficiency of the PV/T system by 14.89%. A better payback period was achieved with a hybrid nanofluid by 54 days with reduced exergy losses by 45.5% and entropy generation by 86.29%.