This study presents an ultimate limit state (ULS) assessment of two optimal dynamic cable layouts, previously proposed by the authors, for a 15 MW floating offshore wind turbine (FOWT). These configurations were evaluated under 50-years return period extreme conditions representative of the Ulsan offshore region. Dynamic cable was modeled using MoorDyn, and fully coupled time-domain simulations were conducted in OpenFAST, accounting for interactions among the FOWT, mooring system and cable. Each layout underwent twelve 3-hour simulations across four sub-DLCs with varying wind and wave phase combinations. Both layouts satisfied all design constraints, with horizontal offsets staying within the ULS criterion of 30% and tension and curvature remaining within acceptable ranges under a safety factor of 2. Higher hang-off tension and Ez angle occurred under upwind conditions, especially in the 230% buoyancy configuration. Sag and hog bend points showed inverse tension-curvature relationships influenced by horizontal offset, with the 230% layout exhibiting lower curvatures due to extended buoyancy distribution. At TDP (touchdown point), wave/current directions governed curvature while horizontal offset controlled tension. Statistical analysis of TDP variability determined optimal cable lengths for both configurations. Future work will extend to fatigue limit state (FLS) evaluation under normal operating conditions to ensure long-term durability.
28 February 2026 in Journal of Ocean Engineering and Technology
Submarine cables operate in complex marine environments and are repeatedly subjected to lateral loads from ocean currents, waves, and seabed irregularities. As these factors often create free spans that undergo substantial bending deformation, understanding the bending behavior of submarine cables is critical for ensuring their structural integrity. In this study, the bending behavior of a 66 kV submarine cable was investigated using a numerical approach, with particular emphasis on a novel modeling methodology that incorporates various conductor wire configurations. The numerical model was validated against experimentally obtained bending moment values through three-point bending tests, thereby ensuring an accurate representation of the structural response of the cable. As a result, the distribution of von Mises stress decreased by up to 27.3% as the cross-sectional area of the conductor wire increased under identical deflection. The single-conductor wire exhibited a bending moment approximately 132.3% higher than that of the 19-conductor wire. These findings indicate that assuming a conductor wire with a fully solid cross-section may lead to overestimation. This underscores the importance of determining the optimal number of conductor wires in 66 kV submarine cables, for which the proposed numerical modeling approach can be adopted.
This work focuses on evaluating the fatigue characteristics of a 66 kV wet-type submarine cable. The analysis incorporates realistic offshore environmental conditions and considers installation through a flexible pull-in system. The target system was deployed at the Southwest Offshore Wind Farm in Korea, where the structural response of the cable is governed by combined wave- and wind-induced loading. To determine the ultimate limit state (ULS) behavior of the cable arranged in the flexible pull-in installation configuration, a global dynamic analysis was initially performed, from which time-dependent displacement histories were extracted under site-specific metocean conditions. The results indicate that lateral wave-induced loading dominates the global response owing to the vertically suspended configuration of the flexible pull-in installation system. A detailed local fatigue analysis was performed based on the critical loading scenarios identified from the global analysis. Prior to the fatigue evaluation, a numerical modeling approach for the local analysis of the 66 kV wet-type submarine cable was developed and validated through comparisons with experimental tensile test results. The developed numerical model successfully captured the axial stiffness characteristics and deformation response of the cable, demonstrating a discrepancy of less than 1% between the numerical predictions and experimental measurements. Fatigue analyses were performed for 120 displacement-based time-history loading cases derived from the global dynamic response. The results show that the fatigue damage is predominantly concentrated in the steel-wire armor, particularly near the fixed boundary region, identifying it as the governing fatigue-critical component. In addition, a parametric study of the wire-armor helix angle revealed that increasing the helix angle significantly improved the fatigue life by enhancing the bending flexibility and reducing the stress concentration under transverse loading. These findings provide practical insights into the fatigue-resistant design and optimization of wet-type submarine cables installed using flexible pull-in installation systems in floating offshore wind applications.