This study evaluate the effect of multiple freeze–thaw (F-T) cycles on the mineralogical and mechanical behaviour of cement-stabilised sand samples with 0, 10, and 20% silt. The results showed that in 28-day samples, the replacement of cement with zeolite enhanced unconfined compressive strength (UCS) and California bearing ratio (CBR). The maximum strength was obtained in samples containing 45% zeolite (Zopt) and water content (ω) equal to 1.2 times the optimum water content (1.2ωopt). The UCS and CBR diminished in all samples under F-T cycles. However, samples containing Zopt had the lowest UCS reduction due to temperature changes. With elevation of Z to greater than Zopt, the strength decreased due to the imbalance between the components affecting the hydration and pozzolanic reactions. Increasing the volume and reducing the weight of the samples as well as the formation of Ettringite mineral are the main factors in reducing the stabilised soil strength.
2 February 2021 in International Journal of Geosynthetics and Ground Engineering
One of the methods for in-site soil treatment is the use of electro-osmosis process. The other method is pre-fabricated vertical drains (PVD). In this research, these two methods combined and used in a soil mass that was subjected to improvement process under three different voltages for 24 days. Changing the soil temperature, moisture content, and pH during the process, at the end of the electro-osmosis, the surrounding soil of the anode and the cathode were subjected to consolidation and XRF test to evaluate and determine the quantity and quality of the elements on the anode and cathode sides, separately. The results showed that with lower voltage, the moisture loss rate of the soil, especially in the early days of the experiment, is significantly reduced, and subsequently the rate of improvement decreased. However, increasing the voltage did not necessarily improve the soil at the anode and the cathode side. Abbreviations: PVD: pre-fabricated vertical drains; pH: potential of Hydrogen
26 October 2019 in Geotechnical and Geological Engineering